Wall mounting
To wall mount your Freestyle 120 Plus
Before you start ensure that the telephone is
in easy reach of the power supply and a
telephone socket. Ensure that the wall can
support the weight of the unit.
• Use the template on the following page to
mark the positions of the screws.
• Drill two holes for the screws and insert the
wallplugs provided (if required).
• Put the screws into the wall leaving about
5mm of screw exposed to mount the
stand/bracket.
• Hook the stand/bracket over the screw heads
to check if it fits correctly, then remove again.
• Ensure that the power supply and the
telephone lines are connected to the base
unit, then fit the lines into the channels on
the bottom of the base unit securing the
lines under the small tabs.
• Any spare length of mains and telephone
lead can be stored in the hollow portion of
the wall bracket, but they should not be
wound around each other.
• Fit the top end of the base unit over the lugs
at the top of the wall bracket.
• Ensure that the lines are fitted into their slots
at the bottom of the wall bracket, clip the
base unit to the bottom of the wall bracket.
• Place the wall bracket (the thin end of the
wedge at the top) over the screw heads and
pull down as far as possible to secure.
Spare parts for your Freestyle 120 Plus are
available from your BT shop or supplier, or you
can contact us on Lo-call 0345 697146 between
9.00am and 5.30pm Monday to Friday.
