631398
75
Zoom out
Zoom in
Previous page
1/101
Next page
64
BUTTONHOLE AND BUTTON SEWING
KNOPFLÖCHER UND KN
ÖPFE NÄHEN
ОБМЕТЫВАНИЕ ПЕТЕЛЬ И ПРИШИВАНИЕ ПУГОВИЦ
Button Sewing
Pattern Stitch Length Stitch Width Foot
(Zigzag Stitch)
Fixed 1.5
(Zigzag Stitch)
0 Fixed 3.5
(Zigzag Stitch)
Fixed 5
1. Measure the distance between the buttonholes and set the
pattern selection dial to the Zigzag Stitch (1.5 mm, 3.5 mm or 5
mm) with the desired width.
2. Change the foot to the Zigzag presser foot.
3. Remove the power supply plug from the outlet. And place the
darning plate on the needle plate. Connect the power supply
plug into a wall outlet.
4. Place a button between the foot and the fabric and make sure
that the needle enters the holes without hitting the button. If it hits
see Step 1.
5. At a slow speed, sew approximately 10 stitches.
6. Remove the material from the machine. Cut the upper and lower
threads and tie both threads at the back of the material.
CAUTION
Make sure the needle does not strike the button during
sewing. The needle may break, leading to injury.
Zigzag
Presser Foot
Нажимная
лапка зигзаг
П ишивание пуговиц
Стежок
Длина стежка Ши ина стежка
Лапка
(Зигзагооб азный стежок)
Фикси . 1,5
(Зигзагооб азный стежок)
0 Фикси . 3,5
(Зигзагооб азный стежок)
Фикси . 5
1. Изме ьте асстояние между цент ами отве стий на
пуговице и установите учку выбо а типа стежка на
зигзагооб азный стежок (1,5 мм, 3,5 мм или 5 мм) с
т ебуемой ши иной стежка.
2. Замените лапку на нажимную лапку зигзаг.
3. Отсоедините штепсель шну а питания от озетки. Затем
положите пластину для штопки на игольную пластину.
Подсоедините штепсель шну а питания к озетке.
4. Разместите пуговицу между лапкой и тканью и убедитесь в
том, что игла но мально входит в отве стия, не задевая
пуговицу. В п отивном случае см. Пункт 1.
5. На малой ско ости сделайте п име но 10 стежков.
6. Снимите ткань с машины. Об ежьте ве хнюю и нижнюю
нитки и свяжите их концы узелком на изнаночной сто оне
ткани.
ПРЕДОСТЕРЕЖЕНИЕ
Убедитесь в том, что игла не задевает за пуговицу во
в емя шитья. Игла может сломаться и п ичинить
т авму.
Zickzack-Nähfuß
Knöpfe annähen
Stichmuster Stichlänge Stichbreite Fuß
(Zickzackstich)
Fixiert 1,5
(Zickzackstich)
0 Fixiert 3,5
(Zickzackstich)
Fixiert 5
1. Messen Sie den Abstand zwischen den Löchern des Knopfes, und
stellen Sie den Musterwähler auf den Zickzackstich (1,5 mm, 3,5 mm
oder 5 mm) mit der dazu passenden Breite.
2. Tauschen Sie den Fuß gegen den Zickzack-Nähfuß.
3. Ziehen Sie den Netzstecker aus der Steckdose. Setzen Sie die Stopf-
platte auf die Nadelplatte. Stecken Sie den Netzstecker in eine Netz-
steckdose.
4. Legen Sie einen Knopf zwischen Fuß und Stoff und prüfen durch
manuelles Drehen, daß die Nadel ohne anzustreifen in die Befestigungs-
löcher einsticht. Wenn dies passiert, beachten Sie Schritt 1.
5. Nähen Sie mit langsamer Geschwindigkeit etwa 10 Stiche.
6. Nehmen Sie das Material aus der Maschine. Schneiden Sie Ober- und
Unterfaden großzügig ab und verknoten Sie beide Fäden an der
Stoffunterseite.
VORSICHT
Achten Sie darauf, dass die Nadel den Knopf während des Nähens
nicht berührt. Die Nadel könnte abbrechen und Sie könnten sich
dadurch verletzen.
75


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother XL-6050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother XL-6050 in the language / languages: English as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother XL-6050

Brother XL-6050 User Manual - German, Dutch, French - 101 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info