480649
51
Zoom out
Zoom in
Previous page
1/104
Next page
48
BAR TACKING
1. Measure the area to be bar tacked and set the length using
the scale on presser foot A. Pull on the end of the button
holder plate to expand it. The finished size of the bar tack will
be the space shown in the illustration.
1 Button holder plate
2 Scale on the presser foot
3 0.5 cm (13/64")
4 Length of bar tack
* 0.5 to 3 cm (13/64" to 1-13/64") is suitable for bar tacking. 0.5
to 1 cm (13/64" to 25/64") is the normal size.
2. Position the pocket as illustrated with the top of the pocket
facing you. Align the needle drop point with the corner of the
pocket to be stitched and move the pocket back 2 mm (5/64")
as shown below.
* After the presser foot lever has been lowered, adjust the
presser foot so that there is no gap behind the section that is
shaded in the illustration at the right. Otherwise,
the size of the stitch will not be correct. To adjust
the presser foot, push the presser foot towards
the back of the machine as shown in the figure at
the left.
* Pass the thread underneath the presser foot.
3. Check the first needle drop point, then lower the presser foot.
1 2 mm (5/64")
4. Lower the buttonhole lever and position it behind the metal
bracket on the buttonhole foot.
1 Metal bracket on buttonhole foot
For reinforcing the openings of pockets, etc.
A
21
4
3
2
1
6
5
6
5
1
A
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother PC 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother PC 3000 in the language / languages: English as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info