480649
43
Zoom out
Zoom in
Previous page
1/104
Next page
40
6. Make a cut of about 2 cm (13/16") in the fabric.
1 2 cm (13/16")
7. Place the fabric as shown left figure B.
Right side of cut: on top of the guide plate
Left side of cut: underneath of the presser foot
1 Guide plate (lower knife)
2 Presser foot
8. Thread the needle, and then pull out a long sec-
tion of the upper thread, pass it below the
presser foot and pull it out in the fabric feed di-
rection. (See left figure B)
2 Presser foot
3 Upper thread
9. Lower the presser foot lever.
CAUTION
If the width has been adjusted, turn the
balance wheel by hand to check that the
needle does not touch the side cutter. If the
needle touches the side cutter, it may cause
the needle to break.
When sewing straight stitches only
The seam margin should be about 0.5 cm (13/64").
1 Seam margin
* Clean the side cutter after use, otherwise dust
and scraps of thread will build up on it.
* Add a small amount of oil as required to the
cutting edge of the cutter.
Note
The fabric will not be cut if the whole fabric is
simply spread out underneath the presser foot
guide plate. Set the fabric as explained in step
7. above, and start sewing.
Check that the needle is raised when the presser
foot lever is raised.
One layer of 13-oz denim can be cut.
1
1
3
2
A
B
5
5
6
5
6
1
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother PC 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother PC 3000 in the language / languages: English as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info