631292
36
Zoom out
Zoom in
Previous page
1/48
Next page
SEWING BUTTONHOLES AND BUTTONS
35
If the button does not fit in the button guide
plate
Add together the diameter and thickness of the
button, and then set the button guide plate to the
calculated length. (The distance between the
markings on the presser foot scale is 5 mm (3/16
inch).)
1 Presser foot scale
2 Length of buttonhole
(Diameter + thickness of button)
3 5 mm (3/16 inch)
Example: For a button with a diameter of 15 mm (9/16
inch) and a thickness of 10 mm (3/8 inch), the button
guide plate should be set to 25 mm (1 inch) on the
scale.
1 10 mm (3/8 inch)
2 15 mm (9/16 inch)
4
Pass the upper thread down through the
hole in the presser foot.
5
You need to sew the front bar tack first.
Lower the presser foot to align the marks
on the foot with the mark on the fabric.
1 Starting mark on the fabric
2 Marks on the foot
6
Lower the buttonhole lever and push it
back slightly.
1 Buttonhole lever
7
While gently holding the upper thread,
start the machine.
8
The bar tacks of the buttonhole are sewn
in the order shown.
9
Stop the machine when buttonhole
stitching is finished.
Note
If buttonhole sewing was interrupted, sew
trial stitching one or two times on a scrap
piece of fabric before continuing to sew the
project. Stitching that is continued after
being interrupted may be sewn incorrectly.
If thick seams are being sewn and the fabric
does not feed, sew with the coarser (longer)
stitch.
0
Raise the needle and the presser foot
lever, remove the fabric, and cut the
thread.
a
Raise the buttonhole lever to its original
position.
1
2
3
1
2
1
2
1
1
3
24
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother LX37NT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother LX37NT in the language / languages: English as an attachment in your email.

The manual is 18,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info