631249
16
Zoom out
Zoom in
Previous page
1/84
Next page
5
KNOWING YOUR SEWING MACHINE
OMPELUKONEESEEN TUTUSTUMINEN
CONOZCA SU M
ÁQ
UINA DE COSER
СВЕДЕНИЯ О ШВЕЙНОЙ МАШИНЕ
1
2
Main Power and Sewing Light Switches
This switch turns the main power and sewing light on or off. (See fig.
A.)
1 Turn on (toward the I mark)
2 Turn off (toward the O mark)
Foot Controller
When the foot controller is depressed lightly, the machine will run at a
low speed. When the pressure on the foot controller is increased, thle
machines speed will increase. When pressure on the foot controller is
released, the machine will stop. (See fig. B.)
NOTE:
1. Be sure that nothing is placed on the foot controller when the ma-
chine is not being used.
2. A new sewing machine or one that has not been in use for a long
period of time should be oiled as described on page 54. After oil-
ing, be sure to wipe off any excess oil.
Note (For U.S.A. only):
Foot Controller: Model KD-1902
This foot controller can be used for sewing machine model LS-1717/
LS-2020/LS-30.
A B
Virta- ja valokytkin
Tällä kytkimellä ompelukoneeseen kytketään virta ja ompeluvalo päälle
ja pois päältä. (Katso kuvaa A.)
1
Kytke päälle (kohti I-merkkiä).
2
Kytke pois (kohti O-merkkiä).
Jalkasäädin
Kun jalkasäädintä painetaan kevyesti, kone ompelee hitaasti. Kun
jalkasäädintä painetaan voimakkaammin, ompelunopeus kasvaa. Kun
jalkasäätimeen kohdistuvaa painetta vähennetään, ompelunopeus hi-
dastuu. (Katso kuvaa B.)
VINKKI:
1. Huolehdi siitä, ettei jalkasäätimen päälle aseteta mitään, kun ko-
netta ei käytetä.
2. Uusi tai kauan käyttämättömänä ollut ompelukone tulee öljytä si-
vun 54 ohjeiden mukaisesti. Pyyhi ylimääräinen öljy pois öljyämisen
jälkeen.
Interruptor principal y de luz
Este interruptor permite apagar y encender la máquina y la luz. (Ver
fig. A.)
1 Encender (hacia la marca I)
2 Apagar (hacia la marca O)
Pedal
Al presionar ligeramente el pedal, la máquina funcionará a baja ve-
locidad. Al aumentar la presión, se incrementa también la velocidad
de la máquina. Al soltar el pedal, la máquina se para. (Ver fig. B.)
NOTA:
1. Asegúrese siempre de no dejar ningún objeto sobre el pedal cuan-
do la máquina no está utilizada.
2. Una nueva máquina de coser o que no haya sido utilizada por
mucho tiempo debe ser lubricada tal como se indica en la página
54. Después de la lubricación, asegúrese siempre de limpiar todo
el excedente de aceite.
Выключатель питания и лампы
подсветки
Этот выключатель включает и выключает питание и лампу
подсветки. (См. рис. A.)
1 Включить (установить в положение “I”)
2 Выключить (установить в положение “O”)
Педаль
Если педаль нажата слегка, машина работает на малой
скорости. Если нажать на педаль сильнее, скорость машины
увеличится. Если педаль отпустить, машина остановится. (См.
рис. B.)
ПРИМЕЧАНИЕ:
1. Если машина не используется, на педали не должно быть
никаких предметов.
2. Если машина новая или долго не использовалась, то перед
началом работы ее необходимо смазать (см. с. 54). После
смазки обязательно удалите тряпкой все излишки масла.
08C713_XE4683-001_P01-24 2008.04.02, 09:295
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother JS-20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother JS-20 in the language / languages: English, Spanish as an attachment in your email.

The manual is 1,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info