631247
20
Zoom out
Zoom in
Previous page
1/116
Next page
GETTING READY
18
Installing the bobbin
Install the bobbin wound with thread.
a
Press (needle position button) once or
twice to raise the needle, and then raise the
presser foot lever.
a Needle position button
b
Turn off the sewing machine (set it to “ ”).
c
Slide the latch on the right side of the bobbin
cover to the right, and then remove the
bobbin cover.
a Bobbin cover
b Latch
d
Insert the bobbin with your right hand so that
the end of the thread is on the left, and then,
after pulling the thread firmly around the tab
with your left hand as shown, lightly pull the
thread to guide it through the slit.
a Tab
Use a bobbin that has been correctly wound,
otherwise the needle may break or the thread
tension will be incorrect.
The bobbin was designed specifically for this
sewing machine. If bobbins from other
models are used, the machine will not operate
correctly. Use only the included bobbin or
bobbins of the same type (part code: SA156,
SFB(XA5539-151)).
a This model
b Other model
c 11.5 mm (7/16 inch) (actual size)
Before installing the bobbin or replacing the
needle, be sure to turn off the sewing
machine, otherwise injuries may occur if the
start/stop button is accidentally pressed and
the machine starts sewing.
CAUTION
ab
c
Be sure to hold down the bobbin with your
finger and install the bobbin so that the thread
unwinds in the correct direction, otherwise
the needle may break or the thread tension
will be incorrect.
ab
CAUTION
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother JK4000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother JK4000 in the language / languages: English as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info