631246
23
Zoom out
Zoom in
Previous page
1/52
Next page
22
1
h
Pull the loop of the thread passed through
the eye of the needle toward the rear of
the machine.
1 Loop of thread
CAUTION
Note
Needle threader cannot be used when using
the twin needle. In this case, thread the
needle as described below.
i
Raise the presser foot lever.
j
Pass the end of the thread through the
presser foot, and then pull out about 5 cm
(2 inches) of thread toward the rear of the
machine.
1 5 cm (2 inches)
Note
If you incorrectly feed the thread you may
cause sewing problems.
Drawing up the lower
thread
You can begin sewing immediately without drawing up
the bobbin thread.
When sewing gathers or darts, you can draw up the
lower thread by hand so that some thread will be left
over. Before you draw up the lower thread, put the
bobbin back in.
1
Raise the presser foot lever.
2
Remove the bobbin cover, and then
reinstall the bobbin.
3
Pass the thread along the slit in the
direction of the arrow, and leave it there
without cutting it.
The bobbin cover should still be removed.
Be careful not to pull on the thread with
force or it may bend the needle.
If the thread does not pass through the
eye of the needle, start from step
c
again.
1
1
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother JK2700NT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother JK2700NT in the language / languages: English as an attachment in your email.

The manual is 18,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info