718767
24
Zoom out
Zoom in
Previous page
1/120
Next page
Winding/Installing the Bobbin
B-16
g
While holding the thread near the spool with your right
hand, as shown, pull the thread with your left hand,
and then pass the thread behind the thread guide cover
and to the front.
1 Thread guide cover
h
Pass the thread under the thread guide plate, and then
pull it to the right.
1 Thread guide plate
i
Pass the thread under the hook on the thread guide,
and then wind it counterclockwise under the
pretension disk.
1 Thread guide
2 Pretension disk
3 Pull it in as far as possible
j
While holding the thread with your left hand, wind the
thread that was pulled out clockwise around the
bobbin five or six times with your right hand.
k
Pass the end of the thread through the guide slit in the
bobbin winder seat, and then pull the thread to the
right to cut it.
1 Guide slit in bobbin winder seat
(with built-in cutter)
l
Slide the sewing speed controller to the right.
1 Speed controller
m
Turn on the machine.
Note
Make sure that the thread passes under the
pretension disk.
1
1
1
2
3
Note
Make sure that the thread between the spool and
the bobbin is pulled tight.
Be sure to wind the thread clockwise around the
bobbin, otherwise the thread will become
wrapped around the bobbin winder shaft.
CAUTION
Be sure to cut the thread as described. If the
bobbin is wound without cutting the thread
using the cutter built into the slit in the bobbin
winder seat, the thread may become tangled in
the bobbin or the needle may bend or break
when the bobbin thread starts to run out.
Note
Bobbin winding speeds may vary depending on
type of thread being wound on bobbin.
1
1
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother Innov-is NV1040SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother Innov-is NV1040SE in the language / languages: English as an attachment in your email.

The manual is 2,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother Innov-is NV1040SE

Brother Innov-is NV1040SE User Manual - German - 116 pages

Brother Innov-is NV1040SE User Manual - Dutch - 116 pages

Brother Innov-is NV1040SE User Manual - French - 116 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info