613440
147
Zoom out
Zoom in
Previous page
1/168
Next page
Troubleshooting 145
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
4
d
While holding the bobbin in place with your
finger, pass the thread through the slit in the
needle plate.
Hold down the bobbin with your right hand,
and then pull the end of the thread around
the tab with your left hand.
a Tab
b Hold down the bobbin with your right hand.
Pull the thread to pass it through the slit in the
needle plate, then cut it with the cutter.
c Slit
d Cutter
Sewing with the correct thread tension is
possible after the bobbin has been correctly
installed in the bobbin case.
Tangled thread on wrong
side of fabric
Symptom
The thread becomes tangled on the lower
side of the fabric.
After starting sewing, a rattling noise is made
and sewing cannot continue.
Looking under the fabric, there is tangled
thread in the bobbin case.
Cause
Incorrect upper threading
If the upper thread is incorrectly threaded, the
upper thread passed through the fabric cannot be
firmly pulled up and the upper thread becomes
tangled in the bobbin case, causing a rattling
noise.
Remedy/check details
Remove the tangled thread, and then correct the
upper threading.
a
Remove the tangled thread. If it cannot be
removed, cut the thread with scissors.
For details, refer to “Cleaning the race” on
page 142.
b
Remove the upper thread from the machine.
c
Refer to the following steps to correct the
upper threading.
If the bobbin was removed from the bobbin
case, refer to “Installing the bobbin” (page
26) and “Remedy/check details” in the
section “
Upper thread tightened up
” (page
144) to correctly install the bobbin.
1
2
147


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother Innov-is 410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother Innov-is 410 in the language / languages: English as an attachment in your email.

The manual is 5,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother Innov-is 410

Brother Innov-is 410 Quick start guide - All languages - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info