681810
52
Zoom out
Zoom in
Previous page
1/286
Next page
CHAPTER 2 GETTING STARTED
2–15
Connecting the Printer to Your Computer
This printer has a bi-directional parallel interface, an RS-232C serial
interface, and a Universal Serial Bus (USB) interface. They allow the
printer to communicate with IBM/PC
®
or compatible computers. Before
connecting the printer and computer, you need to purchase or make a
connecting cable specifically for the interface to be used. See
“INTERFACE SPECIFICATIONS” in Appendix.
Since the automatic interface selection mode has been factory set, simply
connect the interface cable to the printer. In some cases, you need to turn
off the high-speed and bi-directional parallel communications with the
MODE switch. For further information, see “MODE Switch” in Chapter
4.
When you use the serial interface, you need to have the same
communications settings on both the printer and computer. Since the
automatic interface selection mode has been factory set with certain
factory settings (baud rate = 9600, code type = 8 bits, parity = none, stop
bit = 1, Xon/Xoff = ON, DTR (ER) = ON, and Robust Xon = ON), you
may simply connect the interface cable if these are the same as the
settings on your computer. When necessary, set the communications
parameters with the MODE switch on the printer. For further information,
see “MODE Switch” in Chapter 4. For the settings on the computer, see
the manual of the computer or software you use.
Connect the printer to your computer as follows:
1.Make sure that both the computer and the printer are turned off.
!
Caution
Always turn off the printer and computer when connecting and
disconnecting the cable.
When connecting and disconnecting the cable from the Universal
Serial Bus interface, however, it is not necessary to turn off the printer
and computer.
2.Connect one end of the interface cable to the interface connector
located on the back of the printer.
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother HL-2060 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother HL-2060 in the language / languages: English as an attachment in your email.

The manual is 2,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother HL-2060

Brother HL-2060 User Manual - Dutch - 287 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info