613413
35
Zoom out
Zoom in
Previous page
1/48
Next page
34
4
Securing the Stitching and Cutting the
Buttonhole
1
To secure the stitching, turn the material
90 degrees counterclockwise and sew
straight stitches to the end of the front bar
tack of the buttonhole.
2
Remove the material from the machine.
We recommend that you put pins across
both ends of the buttonhole to prevent the
stitches from being cut.
3
Cut an opening in the middle of the
buttonhole with the seam ripper tool. Be
careful not to cut through any stitches.
CAUTION
Adjusting buttonholes
If the stitching on the two sides of the buttonhole is not
the same, you can make the following adjustments.
1
Set the stitch length dial between “F” and
“1.5” and sew the buttonhole on a scrap
piece of fabric to observe how the
material is fed.
2
If the right side of the buttonhole is too
open or tight, adjust the feeding of the
material with the stitch length dial.
1 Right side
2 Shorter
3 Longer
3
After obtaining a satisfactory feed on the
right side, stitch the buttonhole and
observe the feeding.
4
If the left side is too open or tight
compared with the right side, adjust the
buttonhole fine-adjustment screw as
described in the following paragraphs.
1 Buttonhole fine-adjustment screw
2 Left side
3 Buttonhole appearance
Step 3
(Back bar tack)
1. Turn the pattern selection dial to “c” (same
position as in step 1).
2. Sew 5 to 6 stitches.
3. Stop the machine when the needle is at the right
side of the stitch and then raise the needle from the
material.
Step 4
(Right side)
1. Set the pattern selection dial to “d”.
2. Sew the right side until the needle reaches the
stitches sewn in step 1.
When using the seam ripper to open the
buttonhole, do not put your hand or
finger in the path of the ripper. The seam
ripper may slip and you may be injured.
Step Sewn section Pattern
1
2
3
2
3
3
1
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother GS2510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother GS2510 in the language / languages: English as an attachment in your email.

The manual is 13,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info