644489

Brother BE-1204B-BC - PC control Manual

236
Zoom out
Zoom in
Previous page
1/262
Next page
10-6 BE-1204B-BC • BE-1206B-BC
Chapter 10 Adjustment
2. Attachment and Adjustment of Rotary Hook
W1309Q W1310Q
W1311Q W1314Q
W1312Q W1313Q
1. Turn the power switch off.
2. Select the needle bar No. 1 [1].
3. Remove two flat screws [2] and dismount the needle plate [3].
4. Adjust so that the needle [4] and the point of rotary hook [5] should meet at the position (where the
arrow plate aligns with N.H mark (200 û)) higher by 1.7 mm than the needle bar lowest point (180 û ).
Perform this after the height adjustment of the needle bar.
5. Turn the rotary hook manually until the point of rotary hook [5] turns up.
6. Loosen the screw [6] of the rotary hook cutting section and adjust the clearance between the
needle and the rotary hook to be within 0.1 to 0.3 mm.
Confirm that the height of the needle bar is 1.8 mm then.
[5]
[6]
[2]
[1]
[4]
[3]
1.8 mm
Lower shaft
[6]
0.1~0.3mm
1.7 mm
Cutting
section
… 236 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother BE-1204B-BC - PC control at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother BE-1204B-BC - PC control in the language / languages: English as an attachment in your email.

The manual is 7,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info