644489

Brother BE-1204B-BC - PC control Manual

235
Zoom out
Zoom in
Previous page
1/262
Next page
BE-1204B-BC • BE-1206B-BC 10-5
Chapter 10 Adjustment
1. Put the attached T-shaped hexagonal wrench (4 mm) into the hole [1] on the left side of the
machine body, and adjust the arrow plate to align with 180 degrees (N.D mark) to move the needle
bar to the lowest point.
2. Insert the bottom dead center gauge [2] into the rotary hook [3].
3. Loosen the screw [5] of the needle bar clamp [4] and Socket head bolt for top dead center stopper
[8], then move the needle bar up and down until the needle tip touches the gauge [2] lightly.
• The needle point should touch the gauge at a place other than the cutting section.
• The bottom dead center gauge should be set in or removed from the rotary hook with its cutting
section facing upward.
4. Tighten the screw [5] of the needle bar clamp [4] securely.
5. Set the needle bar at the highest position (where the arrow plate and the "N.U.”mark are aligned).
Lightly press the top dead center stopper [6] toward the cushion rubber [7], and tighten Socket
head bolt for top dead center stopper [8] while pressing down the needle bar clamp so that it faces
the front. (Tightening torque: 0.78 N.m)
• Make sure that the top dead center stopper [6] does not hit the needle bar guide rail [9] at this time.
• When tightening the upper dead point stopper bolt [8], insert the longer side of the attached wrench
into the bolt and tighten it by using the shorter side.
Excessive tightening may make the needle bar movement sluggish.
… 235 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother BE-1204B-BC - PC control at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother BE-1204B-BC - PC control in the language / languages: English as an attachment in your email.

The manual is 7,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info