525940
28
Zoom out
Zoom in
Previous page
1/80
Next page
24
Two-thread sewing
How to set the thread change assembly
NOTE:
Be sure to set the thread change assembly to the
machine after completing the needle threading
using the needle threader. (You cannot use the
needle threader with the thread change assembly
set to the machine.)
1. Turn off the machine for safety.
2. Turn the hand wheel so that the mark on the
hand wheel is aligned to the "
TC
" mark on the
machine.
TC
3. Hold the thread change assembly 1 with your
fingertips tightly so that the gap is closed as
shown below.
1
4. While holding the thread change assembly 1,
push the hole of the thread change assembly
onto the upper end of the OL shaft 2 so that
the OL shaft passes through the hole.
5. Push the thread change assembly 2 fully
downward until the tip 3 of the thread change
assembly is put in the eye of the upper looper
4.
Setting of the looper has finished.
Chart of two-thread overlock stitch
Make sure that the tip is in the
eye of the upper looper.
Stitch length
Stitch width
Stitch finger
Thread tension
Left needle
thread
Lower looper
thread
Right needle
thread
Lower looper
thread
For fine
materials
2 (1 - 3)
6 (5 - 7)
2 (1 - 3)
6 (5 - 7)
For medium
materials
2 (1 - 3)
6 (5 - 7)
2 (1 - 3)
6 (5 - 7)
3
5 - 7
Install
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother 5234PRW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother 5234PRW in the language / languages: English, Spanish as an attachment in your email.

The manual is 4,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info