11
Operation
Once the display unit (1) is in place inside the moun-
ting (2), a battery pack(26) with sufficient charge has
been inserted into the e-Bike and the e-Bike System
has been switched on, the display unit(1) is supplied
with power by the battery pack(26).
N.B.: The display unit(1) does not have its own battery
and so cannot be used or operated outside of its moun-
ting(2).
N.B.: As soon as the battery pack (26) is in “Active
Mode”, the display unit(1) always remains switched on
during cycling, even if the motor assist has been deacti-
vated.
Switching on the Brose e-Bike System
− Press the LED button(28) on the battery pack(26).
→ The display unit(1) activates automatically.
→ The e-Bike is now ready to use.
N.B.: Directly after switch-on, the software version num-
ber of the display unit (1) briefly appears in the multi-
functional panel(15).
Switching off the Brose e-Bike System
Standby mode
If the e-Bike is not moving, the display unit(1) and the
drive unit switch to a standby mode. This can however
also be activated manually.
If you want to park your e-Bike only for a short period,
this is how you switch to the standby mode:
− Press the On/Off button(8) briefly(< 2 seconds).
→ This switches off the display unit(1) and the drive
unit.
→ The battery pack(26) remains in the “Active Mode”
for two hours (see „Operating modes of battery
pack“ on page16).
− As soon as you move your e-Bike again, the display
and the drive unit are re-activated and the Brose e-
Bike System is ready to use again.
− After 2 hours in the “Active Mode”, the battery
pack (26) goes into the “Deep Sleep Mode” (see
„Operating modes of battery pack“ on page16).
Complete switch-off
There are two ways to switch off the Brose e-Bike Sys-
tem completely:
− Press the On/Off button(8) for a long time(< 2 se-
conds).
OR
− Press the LED button(28) on the battery pack(26) for
a long time(< 3 seconds).
→ This display unit(1), the drive unit and the battery
pack(26) are completely switched off.
N.B.: For reactivation after complete switch-off, the
system must be restarted using the LED button(28) on
the battery pack (26) (see „Switching battery pack on
and off“ on page16).
[Fig. 5] Displays and settings
The display unit(1) shows various useful information:
− selected assist level(9)
− activity of push-assist(11)
− current cycling speed(12)
− current charge level of battery pack (13) in 10-per-
cent increments
− light mode(14)
− multifunctional panel(15)
Background lighting
The background lighting is activated for 2 seconds
whenever a button is pressed. The brightness here is
100 %.
At night, the background lighting is active all the time.
The brightness is much lower here so that the cyclist is
not dazzled. Brightness is regulated depending on the
ambient light.
Battery charge and remaining range
The charge level(13) of the battery pack is shown in the
display of the display unit (1) with 10 segments. One
segment here corresponds to about 10 % of the battery
capacity(see „Charge level display“ on page15).
Display change in multifunctional panel(15)
− Press the menu button (6) on the display unit to
switch between the functions of the multifunctional
panel(15).
