637985

BroilKing Signet 320 Manual

6
Zoom out
Zoom in
Previous page
1/36
Next page
6
BASIC GAS GRILL COMPONENTS
LIGHTING INSTRUCTIONS
1. The appliance must be assembled as per the assembly
instructions.
2. Ensure LP cylinder is full and properly connected to the
regulator. See: “Hose and Regulator.” (page 4)
3. Ensure there are no gas leaks in the gas supply system.
See: “Leak Testing.” (page 5)
4. Ensure that the venturi tubes are properly located over the
gas valve orifices. (see Venturi diagram, page 5)
5. Ensure that both Main Burner and Side Burner ignition
wires are connected.
6. Carefully review all instructions on the information plate
attached to the gas grill.
7. WARNING: Always open lid before lighting and do not
lean over gas grill while lighting.
8. Set control knobs to “OFF” and turn on the gas supply.
LIGHTING THE MAIN BURNER:
a. Open gas grill lid and leave open until lit.
b. Check that the battery has been installed in the electronic
ignition.
c. Push and turn one main burner control knob to “HIGH.”
d. Push and hold down the ignitor button or use match to light.
e. Burner should ignite within 5 seconds; turn off gas source
immediately if ignition does not occur in this timeframe. To
light burner with a match proceed below to step f.
f. Insert lit match through lighting hole located at the bottom
right of the cookbox.
g. Push and turn right main burner control knob to “HIGH.”
h. Burner should ignite within 5 seconds.
i. After the first burner is lit, push and turn the adjacent main
burner control knob to “HIGH” then repeat for other burners;
these burners should light automatically without the ignitor.
Note: In windy conditions, ignite each burner individually. Use
the match holder to lower a lit match to light each burner.
LIGHTING THE SIDE BURNER:
a. Push and turn side burner control knob to “HIGH.”
b. Push and hold the ignitor button.
c. Burner should ignite within 5 seconds. To light burner with
a match proceed below to step d.
d. Apply lit match to burner ports.
e. Push in the side burner control knob and turn to “HIGH.”
f. Burner should ignite within 5 seconds.
Note: Pots on the side burner must not exceed 9” (23 cm) in
diameter or 15 lbs (7 kg) in weight.
LIGHTING THE REAR ROTISSERIE
BURNER:
Warning: do not operate the main burner simultaneously with
the rear burner.
a. Rear burner must be in place before operating the control
knob.
b. REMOVE THE WARMING RACK.
c. Push and turn rear burner control knob to “HIGH.”
d. Push and hold the ignitor button.
e. Burner should ignite within 5 seconds. To light burner with a
match proceed below to step f.
f. Apply lit match to burner ports.
g. Push in the rear burner control knob and turn to “HIGH.”
h. Burner should ignite within 5 seconds.
CAUTION - Check your gas grill after lighting. All burner
ports should show a 2.5cm / 1” flame on “HIGH.”
If any of the following symptoms occur there is probably a
blockage in the venturi tubes. Shut off gas at once and clean
the venturi tubes. See “Venturi Tubes.” (page 5)
1. You smell gas.
2. A flashback fire occurs.
3. Your gas grill heats unevenly.
4. The burners make popping noises.
IF BURNER DOES NOT IGNITE:
1. Push and turn control knob to “OFF.” Wait 5 minutes then
try again with control knob set at “MEDIUM.”
2. If any burner will not light, see “Troubleshooting” on
page 11. If problem persists, do not attempt to operate
the appliance; contact OMC, your dealer or an approved
service center.
Shutdown:
1. Turn off cylinder valve.
2. Turn control knobs to “OFF.”
LIGHTING
1“
2.5cm
G
F
E
A
B
D
C
H
I
A. Main Burner Controls
B. Side Burner Control
C. Rear Burner Control
D. Ignitor
E. Manual Lighting Hole
F. Handle
G. Side Burner
H. Cylinder Valve
I. Regulator
… 6 …


Need help? Post your question in this forum.

Forumrules
1

Forum

broilking-signet-320

Reset search

  • My broil king grill I bought as a clearance item a couple of years ago and I have used it maybe 4times and it has a hard time starting which now it won’t even start at all what can I try Submitted on 4-7-2021 at 23:26

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BroilKing Signet 320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BroilKing Signet 320 in the language / languages: English as an attachment in your email.

The manual is 4,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BroilKing Signet 320

BroilKing Signet 320 Installation Guide - English, French, Spanish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info