606724
13
Zoom out
Zoom in
Previous page
1/48
Next page
Page 13
system start up
Default Video Output
The default video output for the DVR system is VGA. If you connect a BNC (CVBS)
monitor on initial setup, you will need to use the mouse “Scroll Wheel” to switch to
the BNC output to be able to use the mouse. Roll the mouse “Scroll Wheel” back-
ward to go to BNC and forward to go to VGA. The REMARK screen is shown on
startup.
Power On/Off
To power the system On/Off, connect the power cable to the DC 12V port on the rear
panel. At startup, the system performs a basic system check and runs an initial loading
sequence. After a few moments, the system loads a live display view.
Standby Mode
The system can also be put into Standby Mode.
Power will remain to the system but will not be
recording. To start/stop Standby Mode:
1. Press and hold the POWER button on the
front panel or the STANDBY button on the
remote control until the prompt closes. The
system enters standby mode. You can also
enter Standby mode through the Quick
Access Menu. See next page.
2. To exit standby mode, press and hold the
POWER button on the front panel or remote
control until the system beeps. The system will begin powering up.
User Login
Password
ATTENTION: By default, passwords are disabled on the system. You do not need
to enter a password when accessing any system menus. However, for security
purposes, it is highly recommended to enable passwords on the system using
the Password Menu. See “Password” section for details on setting up passwords.
Click APPLY to access the menus or click EXIT to cancel password setup and
return to the LIVE VIEW screen.
Switch between VGA to BNC Output
initial setup
system operation
Standby Mode
User Login Menu
Power/Standby Switch
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BRK PRO-D1610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BRK PRO-D1610 in the language / languages: English as an attachment in your email.

The manual is 5,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info