542071
2
Zoom out
Zoom in
Previous page
1/2
Next page
*5;.5*:6;
Abnormal air conditions may cause the highly sensitive alarm to give a ‘false’ alarm. DO
NOT DISCONNECT THE ALARM. If no fire is apparent, ventilate the room and/or oper-
ate the alarm pause (If fitted).
'" IF THERE IS ANY QUESTION AS TO THE CAUSE OF AN ALARM, ALWAYS
ASSUME THAT IT IS DUE TO AN ACTUAL FIRE AND FOLLOW YOU FIRE EMER-
GENCY PLANS. Do not assume the alarm is a nuisance alarm and activate alarm pause
(if fitted).
Dust can have an adverse effect. Vacuum as recommended above.
Do not paint the unit.
Other factors such as nicotine contamination may also adversely affect the alarm.
"*-28*,<2>.87<.7<;
Ionisation type smoke alarms utilise a tiny amount of radioactive material, 0.9 microcuries
(30 kilobequerels) of Americium 241, to detect smoke. This material is in the form of a
sealed source and represents no hazard whatsoever to anyone installing or using the
smoke alarm. Any stray particles would be unable to “penetrate the dead layer of skin
and thus do not constitute an external hazard”. (Radiation Protection Guidance for Scien-
tists and Physicians). All BRK® ionisation smoke alarms have been rigorously tested by
the National Radiological Protection Board to ensure absolute safety.
2;98;*5
This product, the batteries and other accessories must not be disposed of as unsorted
municipal waste and must be collected separately at the end of the products life. Con-
tact your local authority for information about collection points in your area.
262<.-0=*:*7<..
BRK (“the BRK Brands Europe Ltd products”) as distributed by Sprue Safety Products
Ltd (“the Distributor”), are guaranteed by the Distributor to be free from defects in materi-
als and workmanship under normal use and service for a period of five years from the
date of purchase.
Neither the Distributor nor BRK Brands Europe Ltd make any guarantees for this prod-
uct. No agent, representative, dealer or employee from the Distributor or BRK Brands Eu-
rope Ltd has the authority to increase or alter the obligations or limitations of the
Guarantee.
The Distributor’s obligation of this guarantee shall be limited to the repair or replacement
of any part of the smoke or heat alarm which is found to be defective in materials or
workmanship under normal use and service during the five year period commencing
from date of purchase. The Distributor shall not be obligated to repair or replace smoke
or heat alarms which are found to be in need of repair because of damage, unreasonable
use, modifications or alterations occurring after the date of purchase. This warranty does
not affect a customer’s statutory rights in any way.
8?<88+<*270=*:*7<..;.:>2,.
If service is required, return the product to your retailer. The Distributor makes no guar-
antee, express or implied, written or oral, including that of merchantability or fitness for
any particular purpose with respect to battery. YOUR ALARM IS NOT A SUBSTITUTE
FOR PROPERTY, DISABILITY OR OTHER INSURANCE OF ANY KIND. APPROPRIATE
COVERAGE IS YOUR RESPONSIBILITY. CONSULT YOUR AGENT. In the event of a
problem with your alarm or you have any questions concerning its use; care and service
please consult this manual.
If you require any further help or clarification please write to:
#9:=.#*/.<@ :8-=,<;<- %72<*:<.:8=:<*>@'*@
'*<.:?.55;=;27.;; *:4!=.-0.5.@58=,.;<.:%72<.-270-86
8:9187.8=:.59527.87A???+:4.5.,<:872,;.=
5.*;.78<.<1*<;9.,2/2,*<287;6*@+.;=+3.,<<8,1*70.
an alarm and may prevent occupants from hearing an alarm on the other side of a
closed door. Install sufficient alarms to compensate for closed doors and other ob-
stacles.
9. Your local fire brigade or insurance company may be able to give you further ad-
vice. Call them and ask. Further help and information may also be found in BS5839
Part 6 and the Fire Safety guidance given by the Department of Transport, Local
Government and the Regions (DTLR).
 "$$ These smoke and heat alarms are intended primarily for use in sin-
gle-family occupancy private dwellings. For use in other applications the manufac-
turers advice should be sought. $#$&
$ locate alarms: -
1. In turbulent air from fans, heaters, doors, windows, etc.
2. In high humidity areas such as bathrooms and shower rooms or where the temper-
ature exceeds 39ºC (100ºF) or falls below 5ºC (40ºF)
3. At the peak of an ‘A’ frame ceiling – dead air at the top may prevent smoke and
heat from reaching the alarm to provide an early warning.
4. Less than 300mm (12 inches) from a wall when mounted on the ceiling.
5. In insect infested areas. Tiny insects may affect performance.
6. (Smoke alarms) in poorly ventilated kitchen or garage. Combustion particles from
cooking or car exhaust could trigger a nuisance alarm
7. In very dusty or dirty areasdirt and excessive dust can impair the performance
of the alarm.
8. Within 300mm (12 inches) of a light fitting or room corners.
9. In locations that would make routine testing or maintenance hazardous. (e.g. over
a stairwell).
10. On poorly insulated walls or ceilings.
11. Near objects such as ceiling decorations that might impede the path of smoke or
heat to the alarm.
12. Within 1500mm (5 feet) of a fluorescent light fitting and keep wiring at least
1000mm (39 inches) from these fittings. Do not install alarms on circuits containing
fluorescent light fittings or dimmer switches.
Further help and information may be found in BS5839 Part 6
%#""$
.*<=:.;
Operating LightsA continuous green light indicates the alarm is receiving mains
power. The red light doubles as an alarm source indicator and flashes approxi-
mately every 45 seconds to confirm circuitry integrity.
Alarm Source Indicator – Red light will flash every second in the unit originating the
alarm. Red lights on other alarms flash every 45 seconds.
Alarm Pause (670 & 650 range only) – Silence your smoke alarm by momentarily
pressing the test button. Ideal when non-emergency smoke (e.g. cooking fumes)
cause nuisance alarms. Red light flashes every ten seconds to remind you that the
alarm has been silenced. Double beep indicates that the alarm has automatically
reset after approximately 10 minutes.
. :.9*:.-
Smoke and heat alarms properly installed and maintained are an essential part of a
good home fire safety programme. Review fire hazards and eliminate dangerous con-
ditions wherever possible. When fire strikes a prepared and practiced escape plan
could prove vital. Your local fire brigade may be willing to advise you. Call them and
ask. Consider and discuss the following safety hints:
• Ensure everyone is familiarized with the alarm signal.
• Always test doors with your hands before flinging them open. If they feel warm, fire
may be walled up behind them – leave closed and find another escape route.
• Don’t waste time collecting possessions. Rouse all occupants and leave the build-
ing; your life is more valuable.
$%$#$)%$$$""%$
• Keep everyone in a set meeting place after your escape.
• If trapped inside, stay close to the floor, cover your mouth with cloth and conserve
breath while you crawl to safety.
• Keep all windows and doors closed except for escape purposes.
• Prepare and practice an escape plan before a fire starts.
Draw a floor plan. Have fire drills often. Practise your escape.
# $
Vacuum every six months to keep unit working efficiently by firstly turning off the
mains electricity supply and vacuuming through the vents using a soft brush attach-
ment. Keep the nozzle from touching the unit. SWITCH POWER BACK ON WHEN
YOU HAVE FINISHED.
Test the alarm once a week by: -
• Checking that the green light is on and that the red light is flashing every 45 seconds
or so. The lights are located behind the grille on the front of the alarm.
• Press and hold the test button until the alarm sounds. NOTE: Pressing this button on
alarms in the 670 and 650 series also places the alarm in pause mode.
(#(((
Change the battery with a new one when the alarm beeps every 45 seconds.
Turn off the mains electricity supply, remove locking key, rotate the alarm approxi-
mately 10mm anti-clockwise and remove the alarm from the ceiling. Unplug the alarm
from the mains supply. Remove the screw and prise open the battery compartment
door on the back of the alarm to replace the battery with one of the following: Duracell
MN1604, MX1604, Eveready PP3B PP3S, 6LF22 Gold Peak 1604A, 1604S. Close the
battery door refit the screw and re-assemble the alarm to the ceiling ensuring that the
mains plug is securely fitted. Test the alarm using the test button then turn on the
mains electricity supply. PLEASE NOTE: The alarm cannot be fitted to the baseplate
without a battery installed.
For 670,650 and 680 series units installed on a DS700 surface mounting base
(770, 750 and 780 series).
1. Turn off the power. Green LED should be off.
2. Using a small flat blade screwdriver gently flex the locking clips on the side of the
base away from the alarm.
3. Using your other hand, disconnect the alarm by gently pulling away from the base.
4. When alarm is removed, remove screw and open battery door on the rear of the
alarm. Replace battery with Duracell MN1604, MX1604, Eveready PP3S, 6LF22,
Gold Peak 1606A or 1604S. Close battery door and refit the screw.
5. Press the test button on the alarm to ensure correct operation be re-installing.
Locate the molded arrow on the side of the base and smoke alarm see fig 3. Posi-
tion the smoke alarm just below the base with both arrows in the same orientation
and locate the alarm onto the base by gently applying pressure until the alarm
‘clicks’ into place.
7. Restore mains power and ensure green LED lights and press the test button to con-
firm operation.
"""
Rechargeable Lithium batteries provide approximately 6 months back up power sup-
ply in the event of a mains supply failure. The alarm may beep every 45 seconds for a
few hours after a mains supply failure while the batteries re-charge.

High performance rechargeable capacitors provide a back up power supply in the
event of a mains supply failure. The alarm may beep every 45 seconds for a few hours
after installation or during/after a mains supply failure. In both of these events the
rechargeable capacitors will need to charge/re-charge when mains supply is restored.
$:8=+5.;188<270
Problems are indicated by four events: -
1. Alarm does not sound upon pressing the test button
2. Green light does not illuminate when mains power is on.
3. Red operating light remains steadily on, or off (i.e. does not flash every 45 seconds
when alarm is in standby).
4. Alarm emits a beep every 45 seconds when back up power supply should be fully
charged.
Try the following: -
1. Inspect the fuse in the power circuit to the alarm
2. Gently vacuum as detailed in ‘Simple Maintenance’.
3. For MBX models only, replace the battery.
4. Call a qualified electrician to inspect the house wiring and connections to the alarm.
If these procedures do not eliminate the problem. DO NOT ATTEMPT REPAIRS. In the
first instance contact the manufacturer for further advice.
If the alarm is still within warranty period and terms, return the unit with proof of pur-
chase to the distributor, indicating the nature of the problem. Units beyond warranty
cannot be economically repaired. For address see the bottom of this page.
Single storey,
one sleeping area
Dining
Room
Dining
Room
Living
Room
Living
Room
Living
Room
TV
Room
Kitchen
Kitchen Garage
Hall
Hall
Kitchen
Bedroom Bedroom Bedroom
Bedroom
Bedroom Bedroom
Bedroom
Bedroom
Smoke alarms for limited protection
Additional smoke alarms for better coverage
Heat alarms
Single storey,
two sleeping areas
Two storey
dwelling
BS5446-2:2003
Licence No: KM85855
BS EN 14604: 2005
Licence No: KM99052
680, 780 Range
650 & 670, 750 &
770 Range
0086-CPD-517190
EN 14604: 2005
# $#%# 
650 & 670, 750 &
770 Range
680 & 780 series
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BRK 670M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BRK 670M in the language / languages: English as an attachment in your email.

The manual is 0.15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BRK 670M

BRK 670M User Manual - Dutch - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info