483906

Brixton KO-6383 Manual

6
Zoom out
Zoom in
Previous page
1/56
Next page
6
Tap markings
liGhtinG your stove
liGhtinG instructions:
• Turn the gas tap control knobs clockwise to “OFF“ position.
• Connect the regulator to the gas bottle. Turn the gas supply “ON” at
the cylinder. Check with the use of soapy water for any gas leakage
between the bottle and the regulator and the appliance connection
• Open the lid fully before lighting the burners. Turn one of the control
knobs turning anti-clockwise to the large ame symbol position, full
rate position whilst holding a match to the burner to be lit, this will light
the burner. If the burner does not light, repeat this process.
• If the burner has not lit after two attempts, turn o the gas tap, wait
5 minutes and then repeat step 3.
• When the burner is lit. The remaining burners may now be lit by
following instructions 3 and 4 above precisely.
• The taps can be adjusted to a low rate position marked with a small
ame symbol or any rate between full and low rate.
• To turn the stove ‘OFF’ turn the cylinder valve or regulator switch to the
‘OFF’ position and then turn all of the control knobs on the appliance
clockwise to the ‘OFF’ position when the ame have extinguished.
• Warning: If the burner fails to ignite, turn the control knob o
(clockwise) and also turn the cylinder valve o before attempting to
relight with ignition sequence.
• Before cooking for the rst time, operate the stove for about 15 minutes
with the gas turned on HIGH. This will “heat clean” the burners.
• Clean your stove after each USE. DO NOT use abrasive or ammable
cleaners, as it will damage the parts of the product. Clean in warm
soapy water.
WarninG: Accessible parts may be very hot. Keep young children away
from the hot appliance at all times (even while cooling down!).
cleaninG and care
caution: All cleaning and maintenance should be carried out when the
stove is cool and with the gas supply turned OFF at the gas cylinder.
cleaninG
outside surface
Use mild detergent or baking soda and hot water solution. Non-abrasive
scouring powder can be used on stubborn stains, then rinse with water.
cookinG Grid
Use a mild soapy water solution. Non-abrasive scouring powder can be
used on stubborn stains then rinse with water.
cleaninG the burner assembly
• Turn the gas OFF at the control knob and disconnect the cylinder.
• Remove pan support.
• Clean the burner with a soft brush or blow clean with compressed air
and wipe with a cloth.
• Clean any clogged ports with a pipe cleaner or sti wire (such as an
opened paper clip).
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brixton KO-6383 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brixton KO-6383 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info