Manual Britax-Romer DUALFIXi-SIZE (page 2 of 2) (English)

767938

Zoom out

Zoom in

1/2

11. USING THE BABY INSERT

6. SAFETY NOTES

Please take the time to read these instructions carefully and keep them

to hand in the intended operating instructions compartment

17 on the

child safety seat at all times. The instructions must be kept with the child

safety seat if the latter is passed on to a third party.

In order for the DUALFIX i-SIZE to protect your child correctly, it must al-

ways be installed and used exactly as described in these instructions. It is

possible that some of the child safety seat settings will lead to restrictions

when used in "i-Size" vehicle seat positions.

DANGER! For the protection of your child:

• In the event of an accident with a collision speed of more than 10km/h, the

child safety seat may be damaged without the damage becoming immediately

visible. In this case the child safety seat must be replaced. Please dispose of

it properly.

• As a rule, have your child safety seat checked if it has been damaged (e.g. if it

falls on the ground).

• Regularly check all important parts for damage. Ensure that all mechanical

parts, in particular, are fully functional.

• Never lubricate or oil parts of the child safety seat.

•

Never leave your child unattended in the child safety seat in the vehicle.

• Only allow your child to enter and exit the vehicle on the pavement side.

• Protect the child safety seat from intensive direct sunlight when it is not in use.

The child safety seat can get very hot in direct sunshine. Children's skin is

sensitive and could be harmed as a result.

•

The more snugly the belt ﬁ ts over your child's body, the better they will be pro-

tected. Therefore, avoid putting thick clothes on your child under the belt.

• Take regular breaks on long journeys in order to give your child the opportu-

nity to run about and play.

• Use on the rear seat: Move the front seat far enough forwards to ensure that

your child's feet cannot hit the backrest of the front seat (to prevent the risk of

injury).

DANGER! For the protection of all vehicle occupants:

In the case of an emergency stop or an accident, unsecured persons or objects

may cause injury to other vehicle occupants. Please always check that ...

• no other load-bearing contact points are used other than those speciﬁ ed in

these instructions and marked out on the child safety seat.

• the backrests of the vehicle seats are locked (e.g. that a folding rear seat

bench latch is engaged).

• all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf) are

secured.

• all persons in the vehicle have their seatbelts fastened.

• the child safety seat is always secured when it is in the vehicle, even if no child

is being transported.

WARNING! For your protection when handling the child seat:

• Never use the child safety seat free-standing, not even for test sitting.

•

To avoid damage, ensure that the child safety seat is not jammed in between

hard objects (vehicle door, seat rails, etc.).

•

Keep the child safety seat in a safe place when it is not in use. Do not place any

heavy objects on the seat and do not store it directly next to sources of heat or

in direct sunlight.

CAUTION! For the protection of your vehicle:

• Certain vehicle seat covers made from more sensitive materials (e.g. velour,

leather) may sustain signs of wear and tear when using child safety seats. For

optimum protection of your vehicle seat covers, we recommend using the

BRITAX RÖMER vehicle seat protector from our range of accessories.

PAGE II

1. If your vehicle is not ﬁ tted with ISOFIX insertion aids as standard, clamp

the two insertion aids 02 , which are included in the scope of delivery of

the seat*, with the opening pointing upwards, to the two ISOFIX fastening

points 01 of your vehicle.

TIP! The ISOFIX fastening points are located between the surface and the

backrest of the vehicle seat.

2. Move the headrest of the vehicle seat into the top position.

* The insertion aids facilitate the installation of the child safety seat with the use of the

ISOFIX fastening points and prevent damage to the vehicle seat covers. As long as they

are not used, remove them and keep them in a safe place. For vehicles with a folding

backrest, the insertion aids need to be removed before folding the backrest. Any prob-

lems occurring usually come from soiling or external objects on the insertion aids and

on the hook. Remove soiling or external objects to rectify such problems.

7. PREPARATORY WORK

8. INSTALLATION OF THE CHILD SAFETY

SEAT

1. ADJUSTING THE SHOCK BAR

1.1 Place the child safety seat facing backwards

(in the direction of travel) on a vehicle seat

which has been approved for use.

1.2 Press the adjustment handle 14 on the shock

bar 10 down with one hand and use the other

hand to pull the shock bar 10 up at the same

time, until it unlocks.

1.3 Adjust the angle of the shock bar 10 to the

angle of your vehicle seat backrest so the

shock bar 10 engages with a clicking sound.

10. USING THE CHILD SAFETY SEAT

2. PREPARING THE ISOFIX

2.1 Pull the grey fabric loop 15 until the ISOFIX

locking arms 16 are fully extended.

2.2 Push the green safety button 06 and the red

release button 05 on both sides of the seat

towards each other. This ensures that both

hooks on the ISOFIX locking arms 16 are

open and ready to use.

3. FASTENING THE ISOFIX

3.1 Position the two ISOFIX locking arms 16

directly in front of the two insertion aids 02 .

3.2 Push both ISOFIX locking arms 16 into the

insertion aids 02 until the ISOFIX locking

arms 16 engage on both sides with a clicking

sound.

DANGER! The green safety button 06

must be visible on both sides so that the child

safety seat is correctly fastened.

4. PUSHING THE CHILD SAFETY SEAT ON

SECURELY

Push the child safety seat as far as possible

towards the vehicle seat backrest.

5. CHECKING THE FASTENING

Shake the child safety seat to ensure that it is

securely fastened and check the safety buttons

06 to make sure that the two indicators are fully

green.

6. INSTALLING THE SUPPORT LEG

6.1 Pull the support leg 21 away from the back of

the child safety seat until you hear a click and

the support leg 21 is fully extended. The red

marking must not be visible any more.

6.2 Push both adjustment buttons 22 and pull

out the support leg 21 until it rests ﬁ rmly on

the ﬂ oor of the vehicle. The indicator on the

support leg 21 must be fully green and the

two adjustment buttons 22 must engage with

a clicking sound.

DANGER! The support leg 21 must never

be suspended in mid-air or supported by

other objects. Make sure that the support leg

21 does not lift the DUALFIX i-SIZE bottom

section 19 up from the surface of the vehicle

seat.

1. LOOSENING THE SHOULDER STRAPS

To loosen the shoulder straps, press the strap

adjustment button 11 and, at the same time, pull

both shoulder straps 09 forwards.

CAUTION! Do not pull the shoulder pads 08 .

2. OPENING THE HARNESS BUCKLE

To open the harness buckle 04 , press the red

button on the harness buckle.

5. ADJUSTING THE HEADREST

A correctly adjusted headrest 03 ensures optimum

protection for your child in the child safety seat:

The headrest 03 must be adjusted so that the

shoulder straps 09 are at the same level as your

child’s shoulders or slightly higher.

To adjust the headrest:

5.1 Loosen the harness (8.1).

5.2 Hold the release button 07 on the headrest

03 down and slide the headrest 03 until it is

at the correct shoulder strap height.

5.3 Check that the headrest 03 is properly en-

gaged by sliding the headrest 03 down a little.

3. POSITIONING A CHILD IN THE SEAT

Place your child in the child safety seat.

Make sure that the harness buckle 04 is folded

forwards and place your child in the child safety

seat.

DANGER! Only use the child safety seat fac-

ing backwards on the passenger seat if the front

airbag has been deactivated.

4. FITTING THE SHOULDER STRAPS

Lay the shoulder straps 09 over your child's

shoulders.

CAUTION! The shoulder straps 09 must not

be twisted or have their places changed over.

6. CLOSING THE HARNESS BUCKLE

Push the two buckle tongues 29

together and

push them into the harness buckle 04

until they

engage with a clicking sound.

7. TENSIONING THE ADJUSTMENT STRAP

Pull the adjustment strap 12 until the strap lies ﬂ at

and snug on your child’s body.

WARNING!

The hip belt must lie as low as pos-

sible over your child's hips.

1. Press the two adjustment buttons 22 on the support leg and push the bot-

tom part of the support leg into the top part until it is fully inserted. Release

the adjustment buttons to ﬁ x the support leg in the inserted position.

2. Loosen the ISOFIX fastening on both sides by pressing the green safety

button 06 and the red release button 05 towards each other.

3. Move the ISOFIX locking arms 16 back into the seat shell 18 .

TIP! The ISOFIX locking arms are protected against damage once they

are pushed back into the seat bottom.

DANGER! The child safety seat must always be secured when it is in the

vehicle, even if no child is being transported.

Please observe the waste disposal regulations in your country.

Disposal of packaging Container for cardboard boxes

Seat cover Residual waste, waste incineration

Plastic parts To be placed in the corresponding

container according to labelling

Metal parts Container for metals

Belt straps Container for polyester

Buckle and tongue Residual waste

12. ADJUSTING THE SEAT ANGLE

The seat shell of the

DUALFIX i-SIZE

can be used in six di erent reclined posi-

tions facing either forwards or backwards:

To adjust the seat angle:

Pull the adjustment handle 13 forwards and push/

slide the seat shell 18 into the desired position.

DANGER! The seat shell 18 must engage

securely with a clicking sound regardless of its posi-

tion. Pull up on the seat shell 18 to ensure that it is

engaged.

►The shoulder straps 09 must be adjusted so that

they run horizontally or just above your child’s

shoulders.

►The shoulder straps 09 are not allowed to run

behind your child’s back, or level with/above their

ears.

Before each car journey, in order to ensure your child’s safety,

make sure that ...

• the child safety seat is fastened in the ISOFIX fastening points

on both

sides with the ISOFIX locking arms

and both ISOFIX indicators

are

fully green;

• the child safety seat is securely fastened;

14. DISPOSAL

13. REMOVING THE CHILD SAFETY SEAT

01 The DUALFIX i-SIZE can be used:

1. From 40–105cm (≤ 18kg) facing backwards.

2. From 15 months up: 76–105cm (≤ 18kg) facing forwards.

To change the direction of travel, press the rotation

button 20 and turn the seat to the desired direction

until it engages.

When facing forwards, the cushioning plate 10 must

be in vertical position.

DANGER! Before making any car journey, ensure

that the rotating part of the child safety seat is fully

engaged by trying to rotate the child safety seat in

both directions.

DANGER! Do not use the child safety seat facing

forwards if your child is under 76cm/15months old.

The baby insert must be used up to a maximum body size of 60cm.

Place the baby insert in the child safety seat and lay both shoulder straps 09

over the baby insert.

Hook the two plastic hooks into the loops on the cover of the headrest 03 .

Guide the harness buckle 04 and the crotch pad through the openings in the

bottom part of the baby insert.

CAUTION! Always make sure that your child is properly secured.

• the support leg

is resting ﬁ rmly on the ﬂ oor of the vehicle and the indica-

tor on the support leg

is green;

• the rotating seat shell

is fully engaged and both indicators are black;

• the harness of the child safety seat is ﬁ tted snugly to the child’s body with-

out being constricting;

• the shoulder straps

are correctly adjusted and the straps are not twisted;

• the shoulder pads

are in the correct position on your child’s body;

• the front airbag is deactivated if you are using the child safety seat facing

backwards on the passenger seat;

• the child safety seat is facing in the right direction for your child's age/size;

• the buckle tongues

are fastened into the harness buckle

CAUTION! If your child tries to open the ISOFIX release buttons

the harness buckle

, stop immediately as soon as possible. Check

whether the child safety seat is correctly fastened and ensure that your

child is correctly secured. Explain to your child the dangers associated

with their actions.

9. CHANGING THE DIRECTION OF TRAVEL

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Britax-Romer DUALFIXi-SIZE in the language / languages: English as an attachment in your email.

The manual is 2,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Britax-Romer DUALFIXi-SIZE

Britax-Romer DUALFIXi-SIZE User Manual - German - 2 pages

Britax-Romer DUALFIXi-SIZE User Manual - Dutch - 2 pages

Britax-Romer DUALFIXi-SIZE User Manual - French - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Britax-Romer DUALFIXi-SIZE Manual

Product: