Manual Britax-Romer DISCOVERY SL (page 2 of 2) (English)

767969

Zoom out

Zoom in

1/2

7. SAFETY NOTES

Please take the time to read these instructions carefully and keep them

to hand in the intended storage compartment 13 on the child safety seat

at all times! The instructions must be with the child safety seat if the latter

is passed on to a third party.

DANGER! For the protection of your child:

• In the event of an accident with a collision speed of more than 10 km/h, the

child safety seat may be damaged without the damage becoming immediately

visible. In this case the child safety seat must be replaced. Please dispose of

it properly.

• As a rule, have your child safety seat checked if it was damaged (e.g if it falls

on the ground).

• Regularly check all important parts for damage. Ensure that all mechanical

parts, in particular, are fully functional.

• Never lubricate or oil parts of the child seat.

•

Never leave your child unattended in the child seat in the vehicle.

• Only allow your child to enter and exit the vehicle on the pavement side.

• Protect the child safety seat from intensive direct sunlight when it is not in use.

The child safety seat can get very hot in direct sunshine. Child skin is sensitive

and could thereby be harmed.

•

The more snugly the belt ﬁts over your child's body, the better they will be

protected. Therefore avoid putting thick clothes on your child under the belt.

• Take regular breaks on long journeys in order to give your child the

opportunity to play around.

• Use on the rear seat: Move the front seat forward far enough that you child's

feet cannot hit the backrest of the front seat (to prevent risk of injury).

DANGER! For the protection of all vehicle occupants:

In the case of an emergency stop or an accident, unsecured persons or objects

may cause injury to other vehicle occupants. Please always check that...

• the backrests of the vehicle seats are locked (i.e. that any foldable rear seat

bench latch is engaged).

• all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf) are

secured.

• all persons in the vehicle have their seatbelts fastened.

• the child safety seat is always secured when it is in the vehicle, even if no child

is being transported.

WARNING! For your protection when handling the child seat:

• Never use the child safety seat free-standing, not even for test sitting.

• When swivelling up the backrest 13, nothing must come between the

backrest 13 and the seat cushion07 . You or your child could pinch your

ﬁngers, injuring them.

•

To avoid damage, ensure that the child safety seat is not jammed in between

hard objects (car door, seat rails, etc.).

•

Keep the child safety seat in a safe place when it is not in use. Do not place any

heavy objects on the seat and do not store it directly next to sources of heat or

in direct sunlight.

CAUTION! To protect your vehicle:

•

Certain car seat covers made from more sensitive materials (e.g. velour, leather,

etc.) may sustain signs of wear and tear when using child safety seats. For

optimum protection of your car seat covers, we recommend using the BRITAX

RÖMER car seat protector from our range of accessories.

PAGE II

A correctly set headrest 12 ensures that the diagonal seat belt section 18 is

optimally positioned, and gives your child optimum protection.

The headrest 12 must be adjusted so that there is a space two ﬁngers wide

between the headrest 12 and your child's shoulders.

To adjust the height of the headrest to ﬁt your child:

1. Unhook the adjustment handle11 on the back of

the headrest12 .

This unlocks the headrest.

2. You can now move the unlocked headrest 12 to

the desired height. As soon as you release the

adjustment handle 11 , the headrest 12 will lock

into place.

3. Place the child safety seat on the vehicle seat.

4. Have your child sit down in the child safety seat and

check the height. Repeat the procedure until the

headrest 12 has the correct height.

8. ADJUSTING THE HEADREST

9. INSTALLATION

With ISOFIT + 3-point belt

10. SECURING YOUR CHILD

With 3-point belt

7. Push both ISOFIT locking arms 04 into the insertion

aids 02 until the ISOFIT locking arm 04 engages

with a clicking sound.

DANGER! Check that the ISOFIT locking arm is

correctly engaged 04 by pulling on it.

9. Press the red ISOFIT locking button

to ensure

that the hook on the ISOFIT locking arm

is open

and ready for use.

10. Push both ISOFIT locking arms 04 into the insertion

aids 02 until the ISOFIT locking arm 04 engages

with a clicking sound.

DANGER! Check that the ISOFIT locking arm is

correctly engaged 04 by pulling on it.

12. Give the child safety seat a ﬁrm pull forwards to

ensure that it is securely fastened and check the

ISOFIT locking arms 04 again to ensure that both

are fully locked in place.

13. Carry out the steps in Section 10 "SECURING

YOUR CHILD".

For the safety of your child, before every journey in the car check that...

Źthe child safety seat is slotted in on both sides with the ISOFIT locking arms

04 in the ISOFIT fastening points 01;

Źthe child safety seat is securely fastened;

Źthe lap belt 17 runs in the bright red belt guides on both sides of the seat

cushion 03 ,

Źthe diagonal seat belt section 18 on the side of the vehicle seatbelt buckle

19 also runs through the light red belt guide 03 of the seat cushion,

Źthe diagonal seat belt section 18 runs through the dark red belt holder 06 of

the headrest,

Źthe diagonal seat belt section 18 runs diagonally backward,

Źthe straps are tight and not twisted,

Źthe seatbelt buckle 19 must not be positioned on the red belt guide 03 in

the seat cushion.

DANGER! If your child tries to open

the red ISOFIT safety button

or the

vehicle belt buckle

, stop the vehicle as soon as safely possible.

Check whether the child safety seat is correctly fastened and

ensure that your child is correctly secured. Explain to your child the

dangers associated with his actions.

1. If your vehicle is not ﬁtted with ISOFIX insertion aids by standard, clamp

the two insertion aids 02 , which are included in the scope of delivery of the

seat*, with the section pointing upwards to the two ISOFIX fastening points

01 of your vehicle.

TIP!

The ISOFIX fastening points are located between the surface and the backrest

of the vehicle seat.

The insertion

aids facilitate the installation of the child safety seat with the use of the

SOFIX fastening points and prevent damage to the car seat covers. As long as they

are not used, remove them and keep them in a safe place. For vehicles with foldable

a backrest, the insertion aids need to be removed before folding the backrest. Any

problems occurring usually come from soiling or external objects on the insertion aids

and on the hook. Remove soiling or external objects to rectify such problems.

2. Moving the headrest of the vehicle seat into the top position.

3. Carry out the steps in Section 8 "ADJUSTING THE HEADREST".

4. Place the child seat facing forward (in the direction of travel) on a suitable

vehicle seat.

The

DISCOVERY SL

is installed permanently in the vehicle with the ISOFIT locking

arms.

Your child is then buckled into the child seat with the vehicle's 3-point seatbelt.

5. Hold the ISOFIT adjustment button 08 down and

fully extend the ISOFIT locking arm furthest from the

vehicle door 04 .

6. Press the red ISOFIT locking button

to ensure that

the hook on the ISOFIT locking arm

is open and

ready for use.

0504

8. Hold the ISOFIT adjustment button 08 down and

fully extend the ISOFIT locking arm nearest to the

vehicle door 04 .

UNFASTENING YOUR CHILD AND REMOVAL:

To unfasten your child or to remove the child safety seat, observe the steps in

Section 6 "REMOVAL AND DISPOSAL" [PAGE I]

0504

1. Carry out the steps in Section 8 "ADJUSTING THE

HEADREST".

2. Place the child seat on the vehicle seat. Ensure that

the backrest 13 is ﬂush with the backrest of the

vehicle seat.

Tip! If the headrest of the vehicle seat gets in the

way, turn it the other way.

3. Carry out the steps in Section 10 "SECURING

YOUR CHILD".

For the safety of your child, before every journey in the car check that...

Źthe child safety seat is securely fastened;

Źthe lap belt

runs in the bright red belt guides on both sides of the seat

cushion

Źthe diagonal seat belt section 18 on the side of the vehicle seatbelt buckle

19 also runs through the light red belt guide 03 of the seat cushion,

Źthe diagonal seat belt section 18 runs through the dark red belt holder 06

of the headrest,

Źthe diagonal seat belt section 18 runs diagonally backward,

Źthe straps are tight and not twisted,

Źthe seatbelt buckle 19 must not be positioned on the red belt guide 03 in

the seat cushion.

DANGER! If your child tries to open the vehicle belt buckle 19 , stop the

vehicle as soon as safely possible. Check whether the child

safety seat is correctly fastened and ensure that your child is

correctly secured. Explain to your child the dangers associated

with his actions.

UNFASTENING YOUR CHILD AND REMOVAL:

To unfasten your child or to remove the child safety seat, observe the steps in

Section 6 "REMOVAL AND DISPOSAL" [PAGE I]

The

DISCOVERY SL

is not installed permanently in the vehicle. It is simply

secured together with your child using the vehicle's 3-point seatbelt.

1. Have your child sit down in the child seat.

2. Pull out the vehicle belt and guide it in front of your

child to the vehicle seat buckle 19 .

DANGER! Ensure the vehicle belt is not twisted, as

otherwise the full protective eect of the

retaining system is not ensured.

3. Engage the buckle tongue in the vehicle seat buckle

19 with a CLICK!

4. Place the diagonal seat belt section 18 and lap

belt section 17 on the side of the vehicle seatbelt

buckle 19 into the light red belt guide 03 of the seat

cushion.

DANGER! The vehicle seatbelt buckle 19 must not

be positioned between the light red belt

guide 06 and the armrest.

5. Also place the lap belt section 17 on the other side

of the seat cushion in the light red belt guide 03 .

DANGER! The lap belt section 17 must lie as low

as possible over your child's hips on both

sides.

6. Guide the diagonal seat belt section 18 into the dark

red belt holder 06 of the headrest 14 until it lies

completely in the belt holder 09 and is not twisted.

Tip! If the backrest 16 conceals the belt holder 06 ,

you can adjust the headrest 14 upwards. The diagonal

seat belt section 18 can now be easily inserted. Now

return the headrest 12 to the proper height.

7. Make sure that the diagonal belt 18 runs over your

child's shoulder, and not in front of his or her neck.

Tip! You can still adjust the height of the headrest 12

again here in the vehicle.

DANGER! The diagonal seat belt section 18 must

run diagonally backward. You can adjust

the course of the belt with your vehicle's

adjustable belt deﬂector.

DANGER! The diagonal belt 18 must never be

directed forwards to the belt deﬂector

on the vehicle. In this case, use the child

safety seat on the back seat only.

Tighten the vehicle seat belt by pulling on the diagonal

seat belt section

18.

9. Observe the further steps and the safety

instructions of the relevant installation type.

17 03

If you have any further questions regarding its use, please feel free to contact us:

18 12

11. Pull on the adjustment belt 09 and push the child

seat backwards at the same time, until the die

backrest 13 is ﬂush with the backrest of the vehicle

seat.

Britax Childcare

Britax Römer

Kindersicherheit GmbH

Blaubeurer Strasse 71

D-89077 Ulm

Germany

T.: +49 (0) 731 9345-199/-299

F.: +49 (0) 731 9345-210

E.: service.de@britax.com

www.britax.com

Britax Childcare

Britax Exelsior Limited

1 Churchill Way West

Andover

Hampshire SP10 3UW

United Kingdom

T.: +44 (0) 1264 333343

F.: +44 (0) 1264 334146

E.:

service.uk@britax.com

www.britax.com

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Britax-Romer DISCOVERY SL in the language / languages: English as an attachment in your email.

The manual is 0,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Britax-Romer DISCOVERY SL

Britax-Romer DISCOVERY SL User Manual - German - 2 pages

Britax-Romer DISCOVERY SL User Manual - Dutch - 2 pages

Britax-Romer DISCOVERY SL User Manual - French - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Britax-Romer DISCOVERY SL Manual

Product: