562809
8
Zoom out
Zoom in
Previous page
1/21
Next page
BrightSign HD120, HD220, HD1020
5
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2012
HDMI connector
Power plug for 5 V power input at 3 A
Power Connector
The power connector on this board is rated for 5 V at 3 A. The plug for the connector is a standard, center-positive 5.5mm
plug with a 1.65mm center pin hole.
DE9 RS-232 Connector
The RS-232 connector is a male DE9. Like PCs, the BrightSign HD series of players are DTE devices. The input to the
chip accepts a range between +30V and -30V, so it is compatible with standard +12V and -12V signaling. The output from
the chip is rated at a typical +7V and -7V, which exceeds the voltage required by the RS-232 specification.
The baud rate is 115,200, with no parity, 8 data bits, and 1 stop bit. There is no hardware or software flow control. The
maximum cable length is 50 meters, and the total cable capacitance is 2500pF.
Note: A lower capacitance cable allows you to use cable lengths beyond 50 meters.
The following diagram illustrates the behavior of the TX and RX signal:
The following table illustrates the pinout of the DE9 on the HD series of players:
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BrightSign HD220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BrightSign HD220 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BrightSign HD220

BrightSign HD220 Quick start guide - English - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info