562810

BrightSign HD1020 Manual

19
Zoom out
Zoom in
Previous page
1/21
Next page
BrightSign HD120, HD220, HD1020
16
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2012
SDRAM
The HD120, HD220, and HD1020 players each contain one DDR SDRAM device. When the BCM7208 boots, it will copy
the code from the NAND flash device into the SDRAM and then execute the code from the SDRAM. The SDRAM runs at
a clock rate of 666MHz, with a data rate of 1333MHz.
Serial Port
The player has a built in UART that communicates with the RS-232 level shifter. The MAX232 creates valid RS-232
voltage levels for the transmit pin by using a capacitive voltage switcher.
Video Encoder and Filter
The BCM7208 streams decoded video using a single-data race clock. It also streams the same video out of the on-board
DACs.
Audio Outputs
The HD120, HD220, and HD1020 players each have a single Texas Instruments high quality audio DAC device, which
takes in digital audio signals from the BCM7208 in an I2S audio format. The AUD_LRCIN is the framing signal for the
audio and runs at the frame rate of the audio source (usually either 44.1KHz or 48KHz). The AUD_BITCLK signal is
typically 64 times higher than the AUD_LRCIN.
The audio output from the TI amplifier is sent directly to the audio output jack. It can drive a 32 Ohm load with a 2 V RMS
signal.
On-Board LEDs
There are four on-board LEDs that indicate the following:
LED Indication
Green power Flashes any time the board is powered up and not in reset mode.
… 19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BrightSign HD1020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BrightSign HD1020 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BrightSign HD1020

BrightSign HD1020 Quick start guide - English - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info