Step 8
When removing the discs - carefully remove
the disc by placing one hand on each side of
the smooth edge and by lifting the disc above
the attachment spindle on the motor shaft.
When removing the processing blades
-
carefully remove the Quad
®
processing blade
or dough blade by grasping the central plastic
support and lifting above the attachment
spindle on the motor shaft.
Reassemble the ikon™ Food Processor
by locking the bowl into position before
attaching blades, disc or lid.
Care should be taken when removing the
food from the processing bowl by ensuring
the motor and Quad
®
processing blade,
dough blade or disc, have completely
stopped before disassembling. Ensure
the OFF button is pressed to switch the
motor off, the appliance is switched off
at the power outlet and it is unplugged,
before removing the lid from the bowl. The
processing bowl should then be unlocked
from the motor body, then the Quad®
processing blade, dough or disc carefully
removed before attempting to remove the
processed food.
Assembling your Breville ikon™ Food Processor
OVERLOAD PROTECTION
SYSTEM
The motor is protected from burning out by
an automatic, temperature operated, cut-
out switch. If the ikon™ Food Processor is
overloaded or operated continuously for too
long, the motor may overheat. If this happens,
the power on light will continue to illuminate
even though the safety cut-out switch will
prevent the food processor from operating.
To operate the food processor again, you
must switch off, unplug and allow to cool for
approximately 30 minutes. Once the motor has
fully cooled, it is ready for use again.
Some stiff mixtures, such as dough, may cause
the dough blade to rotate more slowly than
normal. In this unlikely event of an excessive
load, do not operate the appliance continuously
with excessive load for more than 30 seconds.
If the blades or discs should jam while
processing, ensure the OFF button is pressed
to switch the motor off and the food processor
is switched off at the power outlet and
the power cord is unplugged. Remove the
processing lid and adjust any food wedged
between the blade and the bowl or in the disc.
Replace the lid and proceed as normal. If this
occurs again, the processing bowl may be
overloaded, so remove some of the food and
process in smaller batches.
The ikon™ Food Processor is designed
so the motor will not operate without
the processing bowl and lid correctly
locked into position. In the event that
the food processor starts without the lid
correctly locked into position, immediately
disconnect at the power outlet and return
to your local Breville Service Centre for
examination.
The ikon™ Food Processor can process foods
in a variety of ways depending on which blade
or disc you choose.
