768247
15
Zoom out
Zoom in
Previous page
1/52
Next page
15
before using the car seat. Observe carefully
the drawings during the installaon and fol-
low the dierent stages of installaon.
Keep these instrucons for the enre period
of use. WARNING: This car seat is a safe pro-
duct but only if the instrucons in the user
manual are followed correctly.
Dear Customer, thank you for choosing a Brevi
product.
This child car safety seat has been designed
and approved for children from birth to a
weight of 18 kg.
It has a double standard approval
ECE R44/04:
GROUP 0+ (from birth up to 13 kg weight).
Pic.1
GROUP 1 (from 9 kg up to 18 kg weight). Pic.2
WARNING
Do not use the car seat on front passenger se-
ats provided with air bag. If the car is equip-
ped with airbag the child car seat must be
installed in the backseat of the car.
WARNING
- This is a “Universal” child restraint. It is ap-
proved to Regulaon No. 44, 04 series of
amendments, for general use in vehicles
and it will t most, but not all, car seats.
- A correct t is likely if the vehicle manufac-
turer has declared in the vehicle handbo-
ok that the vehicle is capable of accepng
a “Universal” child restraint for this age
group.
- This child restraint has been classied as
“Universal” under more stringent condi-
ons than those which applied to earlier
designs which do not carry this noce.
- If in doubt, consult either the child restraint
manufacturer or the retailer.
WARNING
Its important to respect the correct steps
when fastening the seat belts. Do not use any
load bearing contact points other than those
described in the instrucons and marked in
the child restraint.
The car seat can be installed on the front pas-
senger seat if it is ed with a 3-point seat
belt (see possible posions on page 2)
It is not possible to install the car seat on a
central front passenger seat.
GROUP 0+
POSITION
When the child weighs less than 9 kg the
child car seat can only be used in the rear-
ward facing posion.
The child car seat must be xed to the car
seat through the three-point safety belt nor-
mally provided in every car.
IMPORTANT!
When the child is in rearward facing posi-
on, use ONLY the adjusng posion n°5.
When the child is in forward facing posion,
use ONLY the adjusng posions from 1 to 4.
To avoid improper use, please adjust the pas-
sage of the lap part of the car seat belt fol-
lowing these instrucons in the right order:
- Place it on the passenger seat rearwards
facing
- Put the lap part (A) of the car seat belt into
the proper seats placed on the base of the
child car seat as shown in pic.3.
- Unroll the car seat belt completely and
place the diagonal part (D) in its housing,
placed on the side of the car seat, as in pic.
4, then behind the back rest of the car seat
- Fasten the car seat belt into its buckle, pic.5
- Push the child car seat against the back rest
of the passenger seat and make sure that
the car seat belt is well ghtened and not
loose, g. 6
- Bolt the belt lock o, pic.7
Only at this stage the child can be placed in
the car seat, following the procedures descri-
bed in the secon “HOW TO FIT YOUR CHILD
INTO THE CHILD CAR SEAT”.
GROUP 1
POSITION
WARNING: Do not use in forward facing po-
sion unl child weighs more than
9 kg.
When your child weighs more than 13 kg, the
child car seat must be used in the forward
facing posion and only on the rear passen-
ger seat.
The car seat must be secured to the seat by
the three-point seat belt provided in each
vehicle.
The abdominal part of the seat belt (A) must
be placed in the back of the car seat base (see
g.8), while the diagonal part (D) will have to
go through the housing located on the side
(see g 9).
Only at this stage the child can be placed in
the car seat, following the procedures descri-
bed in the secon “HOW TO FIT YOUR CHILD
INTO THE CHILD CAR SEAT”.
HOW TO ADJUST THE SEAT IN
DIFFERENT POSITIONS
The seat reclines into 5 dierent posions.
The seat reclines by pressing the lever under
the front part of the child car seat (see g.10).
Adjustment operaons may only be carried
out when the child is not in the product. When
the child car seat is in the posion required,
make sure that the posion-selector locking
pin is inserted in its seat.
IMPORTANT! When the child is in forward
facing posion, use ONLY the adjusng posi-
ons from 1 to 4.
HOW TO FIT YOUR CHILD INTO
THE CHILD CAR SEAT
The tension of the child car seat belts can be
adjusted using the belt locking lever.
Before placing your child in the seat, push on
the “Press” area (there is a lever) and pull both
the shoulder belts (g.11).
Place your child in the car seat, pass the belts
517-14-160801-00 istruzioni GP SPORT_ECE R44-04_13L.indd 15 01/08/2016 16.34.22
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brevi GP Sport at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brevi GP Sport in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 6,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info