784592
5
Zoom out
Zoom in
Previous page
1/40
Next page
-5-
IMPORTANT NOTE!
Beforeeachobservationyoushouldmakesurethatthetiltingmirrorisinthe"UP"position
(14,Fig.2).Forfurtherinformationpleaserefertochapter"Operatingthetiltingmirror"
on page 11.
Assembling the MCX Telescope
To operate the MCX, you need an additional eight AA batteries - the assembly takes place
in just four steps:
1.MounttheLEDviewfinderusingtheAllenkeyasshowninFig.8shownontelescope
tube.
IMPORTANT NOTE!
Make sure that the mirror surface of the LED viewfinder points towards the tube opening
when attaching it.
Formoreinformationontheorientationoftheviewfinder,refertochapter"Use-TheLED
Viewfinder".
2.InserttheSP26mmeyepiece(1,fig.2)intotheeyepiecesocket(4,fig.2).Tightenthe
clamping screw (3, fig. 2) to touch tightness (do not overtighten).
3.Thebatterycompartmentofthetelescope(6,fig.9)islocatedatthebottomofthe
basemotorhousing. Bring the telescope, as pictured in Fig. 9, into a secure lateral
position.Simultaneouslypressthetworetainingclips(4,fig.9)andopenthebattery
compartment.Liftthebatterycompartmentcover(5,fig.9)fromthebasehousing.
Nowinsert theeightAAbatteries intothebattery compartment,observingtheir+/-
orientation, which is indicated on the battery compartment base.
Alternatively,usetherecommendedpowersupplyunit(art.no.0455121).Connectitto
thefemale12Vjacksocketconnector(4,fig.10)foundonthesidepanel.
WARNING!
Insert the batteries with the great care! Do not insert the batteries upside down, do not mix
old and new batteries and only use batteries of the same type. Do not use rechargeable
batteries! If these precautions are not followed, or if batteries (even single ones and only
for a short time) are inserted the wrong way round, irreversible damage may occur to the
MCX itself, which is not covered by the telescopes warranty! Further damage caused by
leaking, heating, possibly burning or bursting batteries, cannot be covered by the warranty
either!
4. Place the telescope upright on a table. Make sure that the power supply switch on the
sidepanel(1,fig.10)isintheOFFposition.Connectthecoiledcableofthehandheld
computertotheHBXsocket(3,fig.10).
The assembly of the MCX telescope is now complete. Now the assembly on the field
tripod follows.
Assembly
Fig. 8
Installation of the LED viewfinder
Bottom view of the MCX:
(1) Thread for the tripod; (2) Drive housing;
(3) Housing screws (!Only to be opened by
authorized service technician!); (4) Holding
clamps; (5) Battery compartment cover; (6)
Battery compartment
Interface field: (1) ON/OFF switch; (2)
accessory port*; (3) HBX connector for
handheld computer; (4) 12V connector; (5)
power supply indicator lamp
*not active on these models, as no suitable
accessories currently available
Fig. 9
bb
c
d
e
f
g
d
d
Fig.Fig. 10 10
b
ce d
f
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bresser MCX Goto Serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bresser MCX Goto Serie in the language / languages: English as an attachment in your email.

The manual is 3.85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bresser MCX Goto Serie

Bresser MCX Goto Serie User Manual - German - 40 pages

Bresser MCX Goto Serie User Manual - Dutch - 40 pages

Bresser MCX Goto Serie User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info