729974

Bresser 7002520 Weather Center 5-in-1 Colour Manual

15
Zoom out
Zoom in
Previous page
1/20
Next page
15
NOTE!
When maximum or minimum reading is displayed, the corresponding
timestamp will be shown.
HI / LO ALERT
HI/LO alert are used to alert you of certain weather conditions. Once
activated, the alarm will turn on and amber LED starts flashing when
a certain criterion is met. The following are areas and type of alert
provided:
Bereich Verfügbarer Alarm-Typ
Indoor temperature HI AL / LO AL
Indoor humidity HI AL / LO AL
Outdoor temperaturw HI AL / LO AL
Outdoor humidity HI AL / LO AL
Rainfall HI AL*
Wind speed HI AL
*Daily rainfall since midnight
HI / LO alert setting (Fig. 29)
1. Press
button several times until the desired area is selected.
2. Use
or buttons to adjust the setting.
3. Press
button to confirm and continue to next setting.
Fig. 29
Enable/Disable HI / LO alert (Fig. 30)
1. Press
button several times until the desired area is selected..
2. Press
button to turn the alert on or off.
3. Press
button again to confirm and continue to next setting.
Fig. 30
NOTE!
1. The unit will automatically exit setting mode in 5 seconds if no
button is pressed.
2. When ALERT alarm is on, the area and type of alarm that triggered
the alarm will be flashing and the alarm will sound for 2 minutes.
3. Press SNOOZE/LIGHT button when alarm sounds to interrupt the
alarm. The alarm will then start again after 5 minutes.
4. Press
button when alarm sounds to deactivate the alarm until
next time.
The alarm automatically turns off after 2 minutes.
WIRELESS SIGNAL RECEPTION
Fig. 31
No sensor Signal searching Strong signal Weak signal Signal lost
The 5-in-1 sensor is capable of transmitting data wirelessly over an
approximate operating of 150m range (line of sight).
Occasionally, due to intermittent physical obstructions or other
environmental interference, the signal may be weaken or lost.
In the case that the sensor signal is lost completely, you will need to
relocate the main unit or the wireless 5-in-1 sensor.
POINTING 5-IN-1 SENSOR TO THE SOUTH
The outdoor 5-in-1 sensor is calibrated to be pointing to North
by default. However, in some cases, users may wish to install the
product with the arrow pointing towards the South, especially
for people living in the Southern hemisphere (e.g. Australia, New
Zealand).
1. First install the outdoor 5-in-1 sensor with its arrow pointing to the
South. (Please refer to 'Installation' chapter for mounting details)
2. Press and hold
button for 8 seconds until the upper part
(Northern hemisphere) of the compass rose is blinking.
3. Use
or button to change to lower part (Southern
hemisphere).
Fig. 32
Northern hemisphere Southern hemisphere
4. Press button again to confirm and exit.
DISPLAY COLOUR CHANGE
1. Press [ LOOP ] key to activate the automatic colour change.
Display changes continuously between 256 colours.
2. Press [ LOOP ] key again to disable colour change function. Press
[ RAINBOW ] key several times to select a colour from the
following and display it permanently: white > red > orange > yellow
> green > light-blue > deep blue > purple
3. Press [ LOOP ] key again to disable colour change function.
Press [ OUTDOOR TEMP ] key to run display colour change
depending on the outdoor temperature. The display colour
changes regarding to the values in the table below:
Temperature range Colour Temperature range Colour
under -20.0° C darkblue 16.1° to 20.0° C orange 2
-19.9° to -11.0° C lightblue 1 20.1° to 24.0° C orange 3
-10.9° to -5.0° C lightblue 2 24.1° to 28.0° C red 1
-4.9° to -2.0° C lightblue 3 28.1° to 32.0° C red 2
-1.9° to 1.0° C white 32.1° to 36.0° C pink 1
1.1° to 4.0° C lightgreen 1 36.1° to 40.0° C pink 2
4.1° to 8.0° C lightgreen 2 40.1° to 45.0° C purple
8.1° to 12.0° C yellow above 45.1° C gray
12.1° to 16.0° C orange 1
TROUBLESHOOTING
Problem/Symptom Solution
Strange or no measurement
of rain sensor
1. Check drain hole in the rain collector. Clean it
if neccessary.
2. Check the circular level. Realign the device if
neccessary.
Strange or no measurement
of Thermo/Hygro Sensor
1. Check radiation shield. Clean it if neccessary.
2. Check sensor housing. Clean it if neccessary
and --- (no signal for
15 minutes)
1. Relocate main unit and 5-in-1 sensor closer to
each other.
2. Make sure the main unit is placed away from
other electronic appliances that may interfere
with the wireless communication (TV‘s,
computers, microwaves).
3. If problem continues reset both, main unit and
5-in-1 sensor.
and ER (no Signal for
1 hour)
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bresser 7002520 Weather Center 5-in-1 Colour at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bresser 7002520 Weather Center 5-in-1 Colour in the language / languages: English, German as an attachment in your email.

The manual is 2,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bresser 7002520 Weather Center 5-in-1 Colour

Bresser 7002520 Weather Center 5-in-1 Colour User Manual - French - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info