Manual Bresser 70-02510 Weather Center 5-in-1 (page 12 of 20) (English, German, French, Italian, Spanish)

632838

Zoom out

Zoom in

1/20

BEFORE YOU START

IMPORTANT!

1. Insert batteries for the main unit before doing so for the remote sensor.

2. Place the main unit as close as possible to the remote unit.

3. Position the remote unit and main unit within the effective transmission

range.

When changing batteries always change batteries in the main unit as well

as all remote units and replace them in the correct order, so the remote

connection can be re-established. If batteries are exchanged in only one

of the devices (i.e. the remote sensor) the signal can’t be received or

can’t be received correctly.

Note, that the effective range is vastly affected by building materials

and position of the main and remote units. Due to external influences

(various RC devices and other sources of interference), the maximum

distance can be greatly reduced. In such cases we suggest to position

the main unit and the remote sensor at other places. Sometimes all it

takes is a relocation of one of these components of a few inches!

POWER SUPPLY

Main unit (Fig. 15)

1. Open the battery compartment door.

2. Install 3 batteries (AA size 1.5V) strictly according to the polarities

shown.

3. Reinsert the battery compartment door.

4. Once the batteries are inserted, all the segments of the LCD will be

shown briefly before entering the radio-controlled time reception

mode.

5. The RC clock will automatically start scanning for the radio-controlled

time signal in 8 seconds.

NOTE!

1. If no display appears on the LCD after inserting the batteries, press the

RESET knob by using a pointed object.

2. In some cases, you may not receive the signal immediately due to the

atmospheric disturbance.

Remote sensor (Fig. 16)

1. Open the battery compartment door.

2. Install 3 batteries (AA size 1.5V) strictly according to the polarities

shown.

3. Reinsert the battery compartment door.

NOTE!

1. Ensure the water tight O-ring is properly aligned in place to ensure

water resistant.

2. The red LED will begin flashing every 12 seconds.

Low battery warning

When it is time to replace the batteries, the respective low battery

indicator will be shown near to the time display (batteries for main

unit) or near to the outdoor temperature (batteries for remote sensor).

INSTALLATION

Remote sensor (Fig. 17-20)

Install the wireless 5-in-1 sensor in an open location with no obstructions

above and around the sensor for accurate rain and wind measurement.

Install the sensor with the smaller end facing the North to properly orient

the wind direction vane.

Add the rubber pads to the rubber pads as shown. Secure the mounting

stand and bracket (included) to a post or pole, and allow minimum 1.5m

off the ground.

Fig. 17/18: Mounting on pole (Pole Diameter 1" - 1.3" (25 - 33mm)).

Fig. 19: Mounting on the railing.

Fig. 20: Circular level.

Mounting guidelines:

1. Install the wireless 5-in-1 sensor at least 1.5m off the ground for better

and more accurate wind measurements.

2. Choose an open area within 150 meters from the LCD display Main

Unit.

3. Install the wireless 5-in-1 sensor as level as possible to achieve

accurate rain and wind measurements. A circular level device is

provided to ensure a level installation.

4. Mount the wireless 5-in-1 sensor with the wind meter end pointing to

the North to correctly orient direction of the wind vane.

Main station (Fig. 21)

Fig. 21

The unit is designed for desktop or wall mount for easy viewing.

Insert the stand so that the pins on the bottom side reach into the

indentions of the station.

The triangular notch on the backside of the main station can be used to

mount the device on walls with a wall screw (not included).

RECEIVING MEASUREMENTS AND TIME SIGNAL

Once batteries are placed in the remote unit, it will start transmitting

temperature readings at roughly 45 second intervals. As soon as batteries

are installed in the main unit it will start searching for a signal from the

remote sensor for about 3 minutes. Upon successful reception of the

signal, the outdoor temperature will be displayed on the main unit. The

main unit will automatically update its readings at about 45 second

intervals.

Subsequently, the main unit will attempt to receive the DCF radio signal.

The reception symbol flashes. When the time signal is received after

3-5 minutes, the current time and date appear in the display. The reception

symbol will now be shown permanently in the display. Date and time are

automatically updated daily at 2:05 o’clock (CET) by the main unit.

Manual pairing after battery change

Whenever you changed the batteries of the wireless 5-in-1 sensor, pairing

must be done manually.

1. Change the batteries to new ones.

2. Press and hold the SCAN button for 2 seconds.

3. Press the RESET button on the sensor.

NOTE!

1. Pressing RESET button at bottom of wireless 5-in-1 sensor will

generate a new code for pairing purpose.

2. Always dispose old batteries in an environmental safe manner.

DATA CLEARING

During installation of the wireless 5-in-1 sensor, the sensors were likely

to be triggered, resulting in erroneous rainfall and wind measurements.

After the installation user may clear all the erroneous data from the main

unit without a need to reset the clock and re-establish pairing.

Simply press and hold the HISTORY button for 10 seconds. This will clear

out any data recorded before.

TIME SETTING

The unit automatically set itself accordingly to the Radio Controlled

Clock signal it received. To set the clock/calendar manually, first disable

the reception by holding the RCC button for 8 seconds.

Manual time setting

1. Press and hold button for 2 seconds until “12 or 24Hr” flashes.

2. Use or button to adjust and press button to proceed to the

My time was right but went out by one hour and when I set it back at 24h00 it go back, same with my sun SER and sun rice Submitted on 12-5-2024 at 06:50
Reply Report abuse
My 5 in 1 weather station is not giving any external humidity or temperature reading. I have cleaned the sensor but there was no real dirt and the situation has not improved. Any ideas? Submitted on 13-3-2022 at 15:03
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bresser 70-02510 Weather Center 5-in-1 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4.14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bresser 70-02510 Weather Center 5-in-1

Bresser 70-02510 Weather Center 5-in-1 User Manual - English, German - 20 pages

Bresser 70-02510 Weather Center 5-in-1 User Manual - Dutch - 12 pages

Bresser 70-02510 Weather Center 5-in-1 User Manual - French - 12 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bresser 70-02510 Weather Center 5-in-1 Manual

Product: