517806
11
Zoom out
Zoom in
Previous page
1/20
Next page
BATTERIES
If the batteries are installed when the
display is completely blank, the
display will remain blank for 5
seconds. After 5 seconds the display
will show “Id” for 1 second, then
display the clock. The remote control
is now ready to use.
The remote control requires 3 AAA
batteries. The use of good quality
alkaline batteries is recommended.
Under normal conditions a set of
batteries will operate for 18 months.
When the batteries are getting low on
power, BATTERY LOW is displayed
on the screen (the cooler may also
switch off while the display remains
ON). This indicates that the batteries
have only a small amount of life
remaining.
To change the batteries remove the
cover from the back of the remote
control. Pull out the old batteries and
replace them all with the new ones.
Do not mix new batteries with old
batteries.
The remote control has 2 minutes of
back-up power to retain its memory
while the batteries are being changed.
Do not use rechargeable batteries as
their voltage rating is too low for the
remote control.
DIP SWITCHES
WARNING: Do not alter DIP
switches 1 to 10 as the cooler
will cease to work.
There are 2 rows of DIP switches
located under the battery cover on
the remote control.
Definition of DIP switch positions
(first 6 in bottom row only) are as
follows:
(A). Reserved for later use.
(B). OFF, 24 hour clock.
ON, 12 hour clock.
(C). OFF, 1100 / 1500W motor.
ON, 380 / 550 / 750W motor.
(D). OFF, no pre-cool.
ON, pre-cool.
(E). OFF, drains 3 days after
power off.
ON, drains 3 hours after
power off.
(F). OFF, drains every 65 minutes
of operation.
ON, activates water salinity
circuit (WaterManager ).
®
ILL217-G
ON
ON
1 2 3 4 5 6 7 8
A B C D E F 9 10
OFF
OFF
EXAMPLE ONLY
AUTO COOL
PM
FAN
SPEED
BATTERY LOW
ILL1106-A
®
10
Evaporative Cooler
TURNING THE COOLER ON
PREPARING TO START
MANUAL MODE
The wall control can be switched
on and off by pressing the
button. The wall control will
remember the previous setting it
was in when the cooler was last
used.
With the wall control switched
ON, press the button
until MAN is shown on the
display.
You may then press the
button to switch between COOL
and VENT (where fresh air is
being delivered but not cooled).
Whenever you select AUTO
mode or COOL in MANUAL
mode, the cooler will take a few
minutes to start as it fills with
water and saturates the cooling
pads. The time will be decreased
if the tank is full or the cooler has
only recently been turned OFF.
During this time PREPARING TO
START will flash on the display.
ILL1122-B
Once COOL or VENT has been
selected, the wall control will maintain
a constant fan speed. This is indicated
by the bar graph shown on the display.
In AUTO mode the cooler will
remember the last setting used and try
to achieve this. It may vary depending
on the day’s conditions. Press the
button if you require more cool
air or the button if you require
less. Don’t alter the setting however,
until the room temperature has
stabilised.
To increase or decrease the fan speed
required, press either the or
button.
To select the AUTO mode press the
button until AUTO is shown on
the display.
AUTO MODE
ILL1124-B
ILL1123-B
SEELEY INTERNATIONAL OWNER’S MANUAL 11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Breezair EX series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Breezair EX series in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info