Manual Braun 9390cc - 5793 (page 13 of 71) (All languages)

695418

Zoom out

Zoom in

1/71

• If you regularly clean the shaver under water,

apply a drop of light machine oil on top of the

Foil & Cutter cassette once a week.

The shaver needs to be cleaned under running

water after each foam or gel usage!

Cleaning with a brush

• Switch off the shaver. Remove the Foil & Cutter

cassette (1) and tap it out on a flat surface. Using

the brush, clean the inner area of the pivoting

head. Do not clean the cassette with the brush as

this may damage it!

Clean & Charge Station (C & C)*

The Clean & Charge Station has been developed for

cleaning, charging, lubricating, disinfecting, drying

and storing your Braun shaver.

12 Station power socket

13 Lift button for cartridge exchange

14 Station-to-shaver contacts

15 Clean & Charge Station display

15a Level indicator

15b Status light

15c Cleaning program indicators*

16 Start button

17 Cleaning cartridge

* not with all models (see display box)

C & C Installation

• Remove the protection foil from the C & C display.

• Press the lift button (13) at the rear side of the

C & C to lift the housing.

• Hold the cleaning cartridge (17) down on a flat,

stable surface (e.g. table).

• Carefully remove the lid from the cartridge.

• Slide the cartridge from the rear side into the base

of the station until it snaps in.

• Slowly close the housing by pushing it down until it

locks.

• Using the power supply (10), connect the station

power socket (12) to an electrical outlet.

C & C Usage

Important: The shaver needs to be dry and free

from any foam, gel or soap residue!

• Insert the shaver in the C & C upside down, with

the front showing and head lock (3) released.

• The contacts (7) on the back of the shaver need to

align with the contacts (14) in the C & C. Push the

shaver backwards in the correct position. A beep

sound confirms that the shaver sits properly in the

C & C.

• Only C & C with cleaning program selection: The

C & C analyses the hygiene status. The status is

shown by the cleaning program indicators (15c) in

the C & C display (15).

Charging the shaver in the C & C

Charging will start automatically when the shaver

has been inserted properly.

Cleaning the shaver in the C & C

When the cleaning indicator lights up on the shaver

display, insert the shaver into the C & C, as

described above.

Cleaning programs (not with all models)

short / economical cleaning

normal level of cleaning

intensive cleaning

Each cleaning program consists of several cycles,

where cleaning fluid is flushed through the shaver

head.

Start automatic cleaning

Start the cleaning process by pressing the start

button (16). If status light (15b) does not shine (C & C

switches to stand-by after ca. 10 minutes), press

start button twice. Otherwise, cleaning will not start.

Depending on your model and / or program

selected, the cleaning time takes up to 3 minutes

and afterwards a fan runs. During this time the

status light (15b) blinks.

After cleaning, drying and charging is completed, all

indicators turn off.

Removing the shaver from the C & C

Hold the C & C with one hand and tilt the shaver

slightly to the front to release it.

Cleaning cartridge / replacement

When the level indicator (15a) lights up permanently

red, the remaining fluid in the cartridge is sufficient

for about 3 more cycles. When the level indicator

blinks red, the cartridge needs to be replaced –

about every 4 weeks when used daily.

After having pressed the lift button (13) to open the

housing, wait for a few seconds before removing the

used cartridge to avoid any dripping. Before

discarding the used cartridge, make sure to close

the openings using the lid of the new cartridge,

since the used cartridge will contain contaminated

cleaning solution.

The hygienic cleaning cartridge contains ethanol or

isopropanol (specification see cartridge), which

once opened will naturally evaporate slowly.

Therefore, each cartridge, if not used daily, should

be replaced after approximately 8 weeks. The

cleaning cartridge also contains lubricants for the

shaving system, which may leave residual marks on

the outer foil frame and the cleaning chamber of the

C & C. These marks can be removed easily by wiping

gently with a damp cloth and do not impact the

shaver and its performance in any way.

91611492_93XXcc_W&D_MN_Type_5793_S6-76.indd 1391611492_93XXcc_W&D_MN_Type_5793_S6-76.indd 13 20.10.17 08:1620.10.17 08:16

CSS APPROVED Effective Date 23Oct2017 GMT - Printed 22Nov2017 Page 13 of 76

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Braun 9390cc - 5793 in the language / languages: All languages as an attachment in your email.

The manual is 7,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Braun 9390cc - 5793 Manual

Product: