Manual Braun 5885 contour (page 6 of 18) (English, French, Spanish)

369501

Zoom out

Zoom in

1/18

Description

1 Shaver foil

2 Cutter block

3 Release button

4 On/off switch («start/stop»)

5 Long hair trimmer

6 Charging lights (green)

7 Low-charge light (red)

8 Replacement light for shaving parts

9 Reset button

10 Special cord set

Charging

The best environmental temperature for

charging is between 60 °F to 95 °F/15 °C and

35 °C.

• Using the special cord set, connect the

shaver/charging stand to an electrical outlet

with the motor switched off.

• When charging for the first time, leave the

shaver to charge continuously for 4 hours.

• Once the shaver is completely charged,

discharge the shaver through normal use.

Then recharge to full capacity. Subsequent

charges will take about 1 hour.

• A full charge provides up to 50 minutes of

cordless shaving time depending on your

beard growth.

• Maximum battery capacity will only be

reached after several charging/discharging

cycles.

• If the rechargeable batteries are discharged,

you may also shave by connecting the

shaver to an electrical outlet via the special

cord set.

Charging lights

The 3 charging lights (6) blink to indicate the

charging level by thirds. When fully charged,

all 3 charging lights shine permanently.

Low-charge light

The red low-charge light flashes when the

battery capacity has dropped below 20%,

provided the shaver is switched on.

The re-maining capacity will then be sufficient

for 2 to 3 shaves.

Shaving

Turn on the shaver («start»):

The pivoting cutting system automatically

adjusts to every contour of your face.

Trimmer:

When the long hair trimmer is activated, it allows

the controlled trimming of moustache or

sideburns.

Cleaning

The hand-held unit should be detached from

the power supply cord before cleaning. The

shaver should not be used until it has dried.

Regular cleaning ensures better shaving

performance. Rinsing the shaving head after

each shave under running water is an easy and

fast way to keep it clean:

• Switch the shaver on (cordless) and rinse

the shaving head under hot running water.

A natural based soap may also be used

provided it contains no particles or abrasive

substances. Rinse off all foam and let the

shaver run for a few more seconds.

• Next, switch off the shaver, remove the

shaver foil and the cutter block. Then leave

the disassembled shaving parts to dry.

Tips for the perfect shave

• It can take up to 14-21 days for your beard

to adjust to the new shaving system.

• Shave before washing your face or taking

a shower, as skin tends to swell after

washing.

• The drier the skin, the closer the shaving

results will be.

• Hold the shaver at right angles (90°) to the

skin. Stretch the skin and shave against

the direction of beard growth.

• To maintain 100% shaving performance,

replace the shaver foil and cutter block,

when the replacement light (8) comes on

(after about 18 months), or when the

shaving parts are worn.

5737450_Contour_5885_NA Seite 6 Donnerstag, 1. März 2007 2:36 14

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Braun 5885 contour in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Braun 5885 contour Manual

Product: