695247
13
Zoom out
Zoom in
Previous page
1/68
Next page
13
After you have replaced the Foil & Cutter
cassette (1), press the on/off switch (4) for
at least 5 seconds to reset the counter.
While doing so, the replacement light
blinks and goes off when the reset is
complete. The manual reset can be done
at any time.
Preserving the batteries
In order to maintain the optimum capacity
of the rechargeable batteries, the shaver
has to be fully discharged (by shaving)
every 6 months approximately. Then
recharge the shaver to full capacity.
Environmental notice
This product contains rechargeable
batteries. In the interest of
protecting the environment, please
do not dispose of the product in
the household waste at the end of its
useful life. Disposal can take place at a
Braun Service Centre or at appropriate
collection sites provided in your country.
C Clean&Renew
Braun Clean&Renew has been developed
for cleaning, charging and storing your
shaver.
Clean your shaver daily in the
Clean&Renew.
During the automated cleaning process,
the shaver is switched on and off at
intervals to obtain best cleaning results.
Since the specially formulated cleaning
fluid contains a small amount of oil,
the cleaning procedure also fulfils the
lubrication needs of the shaver.
Important
Only use the power supply cord set
supplied with the shaver.
In order to avoid any leakage of the
cleaning fluid, place the appliance on a
flat, stable surface. Do not tip, move
suddenly or transport in any way if a
cleaning cartridge is installed.
Do not place the appliance in a mirror
cabinet, nor store it over radiators, nor
place it on polished or lacquered sur-
faces. Do not expose to direct sunlight.
The appliance contains highly flam-
mable liquid. Keep it away from sources
of ignition. No smoking.
Keep out of reach of children. Do not
refill cartridge. Use only original Braun
refill cartridge.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using Clean&Renew
Installing the cartridge
Press the lift button (3) to open the
housing.
Hold the cartridge down on a flat,
stable surface (e.g. table). Carefully
remove the lid from the cartridge. Slide
the cartridge into the base as far as it
will go.
Slowly close the housing by pushing it
down until it locks.
Replacing the cartridge
After having pressed the lift button to
open the housing, wait for a few seconds
before removing the used cartridge.
Before discarding the used cartridge,
make sure to close the openings using
the lid of the new cartridge, since the
used cartridge will contain contaminated
cleaning solution.
The used cartridge can be disposed of in
the household waste.
Operating your
Clean&Renew
Connect your Clean&Renew with the
cord set (10) to the mains electricity
supply. The special socket at the back
is adjustable to save space. After each
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Braun 5411 - 390cc-4 - Boss limited edition at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Braun 5411 - 390cc-4 - Boss limited edition in the language / languages: All languages as an attachment in your email.

The manual is 3,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info