•
Your installation must be protected by a 16 Amp thermal fuse.
•
It is mandatory to use a power point with a ground terminal, connected in accordance with
current safety regulations.
•
In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
•
Never operate the oven if the supply cord and/ or its plug are damaged. In case of damage,
call in a specialised technician trained by the manufacturer.
3
LOCATION
BEFORE CONNECTION
Installation
•
Check whether your oven has not suffered any damage during transport (deformed door
or door seal, etc.). If you see any signs of damage, contact your dealer before use.
•
Verify the power voltage. If there is a PERMANENT undervoltage (200-210 volts), consult your
electrical installer.
ELECTRICAL CONNECTION
•
Place the oven on a flat and horizontal surface, away from any source of heat or steam.
•
The oven should be set at least 85 cm above floor level.
•
Leave sufficient space around the oven : 5 cm between the sides of the oven and any walls or
objects, 14 cm above the oven and 10 cm behind the oven to ensure that air may circulate freely
around the oven.
•
Make sure that nothing obstructs the ventilation louvres at the back of the appliance and that the
electrical plug will be accessible after installation.
•
Please refer to the installation manual included with your oven for further instructions.
