Cleaning your hood ?
The power supply to the hood must be turned off either by removing the plug or by
using the circuit breaker switch before you remove the metal filters. After cleaning, the
metal filters must be refitted in conformity with the instructions.
MAINTENANCE
WHY?
HOW ?
VITAL EVERY MONTH
VITAL EVERY YEAR
This filter traps fatty vapours and dust. This
component plays an important part in
ensuring the effectiveness of your hood.
This filter traps odours and must be
changed at least once a year
depending on your level of use.
Use a commercial household cleaning product then
rinse abundantly and dry. This cleaning can be
carried out in your dishwasher in the vertical position
(ensure that the cartridge never comes into
contact with dirty crockery or silver
tableware).
You should order these filters from
your dealer (quoting the reference
shown on the ID plate located
inside the hood) and note the date
the filter was changed.
FILTER CARTRIDGE
ACTIVATED CARBON FILTER
Never use metal scouring pads, abrasive products or excessively stiff brushes.
To clean the body and the lighting port, you should use only commercial household cleaning products
diluted in water and then rinse using clean water, drying with a soft cloth.
Remove the protective film before using the
filter cartridge for the first time.
For hoods installed in
"recycling" mode.
To avoid all risks of fire.
ANNUAL MAINTENANCE: active carbon filter
ONLY for those hoods installed as "recycling" versions (i.e. - not connected to an
external outlet). This filter traps odours and must be changed at least once a year (depend-
ing on how intensively you use it), in order to avoid all risks of fire. You should order the fil-
ters from your dealer (quoting the reference number shown on the I.D. plate located inside
the hood). Be sure to note the date on which the filter is changed.
Dismantling the filter cartridge
(Fig. 10)
Assembling the carbon filter (standard model)
Fig.13
1. Remove the cartridges.
2. Place the carbon filter on the cartridge, on the inner side of the hood.
3. Fit the 2 fastener clips.
4. Repeat this operation on all of the cartridges.
Assembling the carbon filter (silent model)
Fig. 12
Place both filters on both sides of the motor, screwing them
into place.
