737207
11
Zoom out
Zoom in
Previous page
1/16
Next page
Equipment must be examined for damage and repairs before each use. The owner is responsible to perform routine testing of the
locking mechanisms. Worn or damaged components must be replaced immediately or the equipment removed from service until
the repair is made. Only manufacturer supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased in US/Canada, contact
Customer Service for replacement labels. If purchased outside US/Canada, contact your local distributor for them.
The Bowflex™ SelectTech™ Dumbbell is a very low maintenance product. However, there are steps that you should take to keep the product
performing and looking its very best.
Should your SelectTech™ Dumbbell handle assembly, plates or base become soiled you may clean them with a cloth lightly dampened with
warm water and a small amount of mild soap. Wipe dry with a separate cloth.
The SelectTech™ Dumbbell is internally lubricated and will not require further internal lubrication. The contact between weight plates and
selection discs is not lubricated but has naturally low friction. This generally will not require any lubrication. Should you feel it necessary to
lubricate the weight plates and/or selection discs, use only a silicon lubricant, preferably “food grade”.
Do not use any solvents, harsh detergents, chemicals or bleach on this product − doing so may damage the materials, resulting in
degradation of the product’s performance or strength.
Do not attempt to disassemble the Handle Assembly. The Handle Assembly is not designed to be user serviced. Doing so will
void the manufacturers warranty. If purchased in US/Canada, contact Customer Service for assistance. If purchased outside US/
Canada, contact your local distributor for assistance.
Battery Icon Displayed on the Smart Dumbbell Module
The Console will display the battery icon for ten seconds when the batteries are at approximately 10% of their rated power
during power up. When replacing the batteries, make sure the batteries point in the +/- direction shown in the battery bay.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc) batteries.
1. Press and hold down the securing snap on the Sensor Assembly, and pivot the Sensor Assembly up and out from the dumbbell.
Maintenance
Assembly / Owner’s Manual
11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bowflex SelectTech 560 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bowflex SelectTech 560 in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bowflex SelectTech 560

Bowflex SelectTech 560 User Manual - German - 16 pages

Bowflex SelectTech 560 User Manual - Dutch - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info