Manual Bowers Wilkins CT SW15 (page 7 of 108) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

706602

Zoom out

Zoom in

1/108

cathode ray tube televisions or computer

monitors, audio and video tapes and swipe cards)

within 0.5m (2 feet) of the appliance. The

appliance may cause distortion of cathode ray

tube images beyond this distance. LCD and

Plasma screens are not affected.

26. Mounting – Do not place this product on an

unstable stand, tripod, bracket or table. The

product may fall causing serious injury and serious

damage. Any mounting of the product should

follow the manufacturer’s instructions.

Do not expose the device to rain, use it near water or

in damp or wet conditions, or place containers on it

containing liquids which might spill into any openings.

When setting up the device, make sure that the AC

outlet you are using is easily accessible. If some

trouble or malfunction occurs, immediately turn off the

power switch and disconnect the plug from the outlet.

Even when the power switch is turned off, electricity is

still flowing to the product at the minimum level. When

you are not using the device for a long time, make

sure to unplug the power cord from the wall AC outlet.

Introduction

Dear customer,

Thank you for choosing Bowers & Wilkins. Please read

this manual fully before unpacking and installing the

product. It will help you to optimise its performance.

B&W maintains a network of dedicated distributors in

over 60 countries who will be able to help you should

you have any problems your dealer cannot resolve.

Environmental Information

All B&W products are designed to comply

with international directives on the

Restriction of Hazardous Substances

(RoHS) in electrical and electronic equipment and the

disposal of Waste Electrical and Electronic Equipment

(WEEE). These symbols indicate compliance and that

the products must be appropriately recycled or

processed in accordance with these directives. Consult

your local waste disposal authority for guidance.

This manual covers the CT SW10, CT SW12 and

CT SW15 subwoofers and their matching SA1000

automated rack mount power amplifier.

Carton Contents

Check subwoofer carton for:

1 Accessory pack containing:

4 x M6 spike feet

4 x M6 rubber feet

4 x Lock nuts (10mm across flats)

1 x Two-pole Neutrik Speakon plug

Check amplifier carton for:

1 x Mains Cable

1 x Four-pole Neutrik Speakon plug

2 x Rack Mount Brackets

6 x Short Philips screws and washers

4 x Rubber hole plugs

2 x Handles

4 x Long Philips screws and washers

The CT SW10, 12 and 15, and the SA1000 dual

subwoofer amplifier are designed both for Home

Theatre installations and to augment the bass

performance of ‘full range’ speakers in 2-channel

audio systems. All audio installations require some

thought in installation if they are to reach their full

performance potential and this manual will guide you

through the process.

The subwoofer amplifier requires connection to the

mains power supply so it is important that you

familiarise yourself with the safety instructions and

heed all the warnings. Keep this manual in a safe

place for future reference.

Subwoofer Installation and Positioning

The CT SW Series subwoofers are intended to be

installed either within existing or custom designed

home theatre system cabinetry close to, or on, the

floor.

If the subwoofer is to be installed within cabinetry it is

important to ensure that the cabinetry is capable of

carrying the weight and that it is structurally reliable.

Significant vibration of the cabinetry panels may

seriously affect the subjective performance of the

audio system. Screw-in rubber feet are supplied for

attachment to the underside of the subwoofer in order

both to protect the cabinet finish and to reduce

vibration.

If the subwoofer is to be installed free-standing on the

floor, it is important to ensure it stands firmly using the

spike feet supplied whenever possible. The spike feet

are designed to pierce carpet and rest on the floor

surface. Initially, screw the lock nuts onto the spikes

enough to leave the nuts floating just above the carpet

when the spikes are resting on the floor beneath.

Screw the spikes fully into the threaded inserts in the

base of the cabinet. If the cabinet rocks when placed

on the floor, unscrew the spike that does not touch

the floor until the cabinet rests firmly without rocking.

Finally, lock the nuts against the cabinet. It may be

more convenient to fit and adjust the spike feet after

speaker positioning has been optimised.

The ear poorly perceives the source location of low

frequency sound so the position of subwoofers in the

listening room is generally less critical compared to

full-range speakers. That said however, best results

are usually obtained if the subwoofer is placed

between the left and right speakers or in the vicinity of

one of them. If two subwoofers are used it is best to

put one near the left and one near the right speaker.

Placing a subwoofer behind the listening position,

even in multi-channel surround sound installations,

generally results in inferior imaging but may be an

acceptable compromise if domestic considerations

dictate.

As with all speakers, the proximity of room boundaries

affects the sound of a subwoofer. Bass volume

increases as more surfaces come into close proximity

with the speaker. Unlike full-range speakers, however,

the overall system balance can be corrected by

adjusting the volume level of the subwoofer. The more

boost gained from the room, the lower the volume can

7575 CTSWxx SA1000 Inside 13/1/09 9:45 Page 4

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bowers Wilkins CT SW15 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 20,46 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bowers Wilkins CT SW15 Manual

Product: