582027

Bowers Wilkins 685 S2 Manual

5
Zoom out
Zoom in
Previous page
1/59
Next page
ENGLISH
5
If you wish to angle the speaker to the wall, you may use a third-
party ball joint type bracket attached to the bracket already xed
to the speaker. You should ensure that the ball-joint bracket is
capable of supporting the weight of the speaker. Your dealer or
local Bowers & Wilkins distributor will be able to advise you on the
selection of appropriate ball-joint brackets.
To attach a ball-joint style mount to a 686 S2 speaker, remove the
bracket from the back panel of the speaker and securely attach
the ball component through the central slot. Reattach the bracket
and ball assembly to the back panel (see above).
Once the ball joint component is attached to the speaker, the
assembly may be connected to the socket component attached
to the wall. Ensure that the Manufacturer’s instructions for
attaching the bracket to the wall are followed correctly.
B&W Group Ltd. can accept no liability for any failure of wall
xings.
2. Positioning
Speaker Installation
The speaker is primarily designed to be mounted on a dedicated
oor stand, but may be placed on a shelf, although this offers less
exibility to optimise the speaker’s performance. In both cases,
the tweeter should be approximately at ear height.
Note: If using a shelf, ensure that it is strong enough to
properly support the weight and t the 4 self-adhesive
plastic feet to the underside of the speaker.
The 686 S2 speaker can be mounted on a wall using the bracket
already attached to the back panel. The simplest method is to
use a single screw into the wall and hook the bracket over it, in
which case you should stick one of the supplied plastic stand-offs
close to each of the bottom corners of the back panel to make
the speaker sit parallel to the wall and avoid rattles. Make sure
that the screw, any wall plug and the amount of insertion into the
wall are sufcient to support the weight of the speaker. The slot in
the bracket is 10mm wide, so you may use a woodscrew up to
No. 24. We suggest a minimum size of No.14 or 6mm diameter.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bowers Wilkins 685 S2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bowers Wilkins 685 S2 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 8,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info