582229
5
Zoom out
Zoom in
Previous page
1/72
Next page
5
Position subwoofer
in corner for maximum
bass output
Unpacking the System
Carefully unpack the speakers. If there is any sign of damage from transit, report it immediately to your dealer or delivery service.
Retain the shipping carton and packing materials for future use.
Grilles
The cloth grilles should remain on the speaker during normal use. However, to remove a grille, use your fingers to carefully
pry the top edge of the grille away from the cabinet so you can insert your fingers between the grille and the cabinet. Then
slide your fingers down the inside of the grille frame from top to bottom which will cause the grille to pop free. The grille is
NOT designed to be removed by only pulling on one side. The pins that hold the grille can be damaged. Also, do not use any
objects other than your fingers to remove the grille as the finish or grille may be damaged. Be careful to keep rings, watches
and other sharp objects from scratching the finish or tearing the grille cloth.
To replace the grille, carefully align the two pins at the top of the grille with their corresponding grommets and gently push
them in until the grille is supported by the grommets. Then work your way down the grille gently pushing the grille pins into
the grommets evenly until the grille is fully seated. Be careful to align the pins with the grommets so the cabinet, grille pins
and grommets are not damaged. Also, take care to support the speaker so it does not tip over or fall off its mounting location
while the grille is being removed or replaced. MCenter Note: The same grille removal and replacement procedures apply
to the MCenter except you will begin at the left or right side and work towards the opposite side. MSubwoofer Note: The
MSubwoofer grille is not removable.
Feet & Spikes
The M350, M340 and M250 come with rubber feet installed at the factory which are ideal for hardwood floors. Spikes are also
included for placement on a carpeted surface. To install the spikes, carefully lay the speaker on its back on a soft, debris-free
surface and remove the rubber feet by hand turning them counter-clockwise. Thread the spikes by hand to make sure they
are inserted properly. Save the rubber feet for future use.
The M25, MCenter, and MSurround come with rubber stand-offs that are designed to be attached to the bottom of the
loudspeaker
when stand, shelf or cabinet mounting. This will minimize the vibration transferred from the loudspeaker to the
stand, shelf or cabinet. It will also help to protect the finish of the loudspeaker and the mounting location. The MSubwoofer
comes with rubber feet installed at the factory.
MSurround Note: It is recommended to mount the rubber stand-offs on the back of the side panels of the MSurround if it is
going to be wall mounted. This will minimize the amount of vibration that is transferred directly to the wall. You may need to
adjust the depth of the mounting screws to help ensure that the speaker is not mounted too loosely or too tightly.
Where to Place the Speakers
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Boston M 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Boston M 350 in the language / languages: English, German, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 4,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info