791913
22
Zoom out
Zoom in
Previous page
1/578
Next page
22 EN
SETUP
Cable Management
The included cable management cover can hold all permanent cabling in
place against a wall.
To install the cable management cover:
1. Place and hold the back of the cable cover (the piece with the screw
holes) against desired location on wall.
2. Mark the center of the two screw holes on wall, and remove the back of
the cable cover.
3. If that part of the wall has a stud behind it, drill two 2.4mm (⁄in)
holes into the wall.
If that part of the wall has no stud behind it, drill two 5mm (⁄in)
holes into the wall.
4. If that part of the wall has no stud behind it, drive the two small drywall
anchors (G) into the wall.
5. Align the back of the cable cover with the screw holes.
6. Drive the two small flat-head screws (F) into the back of the cable
cover to secure it to the wall.
7. Gather the cables and place along the “guide” of the back of the cable
cover (on the wall).
8. Remove the adhesive strip from the cable cover foam.
9. Firmly place the foam strip on the back of the cable cover, next to the
gathered cables.
10. Place the front of the cable cover over gathered cables and foam so it
adheres.
Cable management plate,
foam, and cover
F
GSmall drywall anchor (2)
Small flathead screw (2)
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bose Videobar VB-S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bose Videobar VB-S in the language / languages: All languages as an attachment in your email.

The manual is 57.52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info