791923
19
Zoom out
Zoom in
Previous page
1/236
Next page
English - 19
Care and Maintenance
Replacing the remote batteries
Solo 15 series II system remote control
Replace both batteries when the remote control stops operating or
its range seems reduced. Use Alkaline batteries.
1. Slide open the battery compartment cover on the back of
the remote.
2. Remove both batteries.
Dispose of the batteries according to the regulations in
your area.
3. Insert two AA (IEC-LR6) 1.5V batteries or the equivalent. Match
the + and – symbols on the batteries with the + and – markings
inside the compartment.
4. Slide the battery compartment cover back into place.
Solo 10 series II system remote control
Replace the battery when the remote control stops operating or its
range seems reduced. Use a lithium battery.
1. Using a coin, turn the battery cover slightly left.
2. Remove the cover and insert the new battery (CR2032 or
DL2032) flat side up, with the plus (+) symbol in view.
3. Reseat the cover and turn it right to lock into place.
WARNING: Do not ingest battery, chemical burn hazard.
The remote control supplied with this product contains a
coin/button cell battery. If the coin/button cell battery is
swallowed it can cause severe internal burns in just two
hours and can lead to death. Keep new and used batteries
away from children. If the battery compartment does not
close securely, stop using the product and keep it away from
children. If you think the battery may have been swallowed or
placed inside any part of the body, seek immediate medical
attention. The coin/button cell battery may explode or cause
a fire or chemical burn if incorrectly replaced or mishandled.
Do not recharge, disassemble, heat above 212°F (100°C) or
incinerate. Replace only with an agency approved (ex. UL)
CR2032 or DL2032 3-volt lithium battery. Dispose of used
batteries promptly.
Cleaning
Clean the surface of the system with a soft, dry cloth.
Do not use any sprays near the system. Do not use any solvents,
chemicals, or cleaning solutions containing alcohol, ammonia or
abrasives.
Do not allow liquids to spill into any openings.
Customer service
For additional help, contact Bose Customer Service. Refer to the
contact sheet in the carton.
Limited warranty
Your system is covered by a limited warranty. Details of the limited
warranty are provided on the product registration card in the
carton. Please refer to the product registration card for instructions
on how to register. Failure to register will not affect your limited
warranty rights.
The warranty information provided with this product does
not apply in Australia or New Zealand. See our website at
www.bose.com.au/warranty or www.bose.co.nz/warranty for
details of the Australia and New Zealand warranty.
Technical Information
Power rating
100-240V 50/60 Hz 50W
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bose Bose Solo 15-10 series II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bose Bose Solo 15-10 series II in the language / languages: All languages as an attachment in your email.

The manual is 15.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info