12
What to do if ...
ʠ
Drying result was not achieved
(laundry too damp).
Warm laundry feels damper than it really is.
The selected programme does not suit the load.
Use another drying programme or, in addition, select the
time programme a Programme overview, Page7.
Use the « Ð
üAdjust drying level » option a Page 5.
Thin layer of limescale on the moisture sensors?
Clean the moisture sensors aInstallation and
maintenance instructions, Page 2.
Programme termination, e.g. condensation container full,
mains power supply failure, door open or maximum drying
time reached.
ʠ
Drying time too long.
Clean the fluff filters under running water a Page 4.
Insufficient supply of air a Ensure that air can circulate.
Air inlet may be obstructed? Clear the inlet a Installation
and maintenance instructions, Page 1.
Ambient temperature higher than 35 °C a Ventilate
the room.
ʠ
The humidity in the room
increases significantly.
Make sure the room is sufficiently ventilated.
ʠ
Heat exchanger is being rinsed
is displayed in the display panel.
Not an error. Automatic cleaning of the heat exchanger.
Do not empty the condensation container during
the cleaning process.
ʠ
Power failure. Remove the laundry from the dryer immediately and
spread out. This allows the heat to dissipate. Be careful as
the door, the drum and the laundry may be hot.
ʠ
Other intermittent noises and
vibrations.
Normal noises a Page 10.
13
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
dryer...
– in rooms inside the house.
– to dry fabrics.
The dryer must
NEVER...
– be used for purposes other than those described above.
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets, and lighters in particular
a Risk of explosion.
– Do not lean or sit on the door a Risk of tipping.
– Open the door carefully. Hot steam may escape. Fabrics and drum may be hot
a Risk of burns.
Installation
– Secure loose leads or hoses, otherwise there is a risk of tripping.
– Below 0 °C there is a possibility of frost damage.
Mains connection
– Connect the dryer to an AC earthed socket according to specifications,
otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
– Do not touch or hold the appliance plug with wet hands
a Risk of electric shock.
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead a Risk of electric shock.
Operation
– Only load the dryer as recommended in the programme descriptions
(Programmes/fabrics, Page 1 and Programme overview, Page 7) . Check the
contents before you switch the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair styling products, nail varnish remover, stain remover,
cleaning solvent, etc.) a Risk of fire/explosion.
– Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer
a Risk of explosion
– Do not turn off the dryer until the drying process ends, unless the laundry will
be removed quickly and spread out, so that the heat can dissipate.
– Do not put laundry containing foam material/rubber in the dryer
a elastic material may be destroyed and the dryer may be damaged due to
possible deformation of the foam material.
– Light things, such as long hair, may be sucked into the air inlet of the dryer a
Risk of injury.
– Switch off the dryer once the programme has ended.
– The distilled water/water from condensation is not drinking water
and may be contaminated with fluff.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer if the mains cable is defective. To avoid danger,
only have the defective mains cable replaced by the after-sales service.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Dryer: Pull out the appliance plug, then cut off the mains cable from
the appliance.
Dispose of the appliance at a municipal waste disposal facility.
– Packaging: Keep all packaging out of reach of babies and children
a Risk of suffocation.
– Heat exchangers contain a fluorinated greenhouse gas covered by the Kyoto
protocol (R407C) a Dispose of this properly. Capacity: 0.385 kg.
– All materials are environmentally sound and can be reused.
Dispose of in an environmentally-responsible manner.
