8
Installation
– Scope of delivery: dryer, installation and instruction manual, basket for woollens
(depending on the model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
– Do not install in a room which is susceptible to frost. Water may cause damage once it
starts to freeze.
– If in doubt, have the appliance connected by a specialist.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
Setting up the dryer
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean,
level and firm surface.
– Do not obstruct the air inlet on the front of the
dryer.
– Keep the area around the dryer clean.
– Level the dryer using the threaded feet.
Use a spirit level.
– Do not remove the threaded feet under any
circumstances.
Mains connection see safety information a Page 13.
– Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (a Page 10 ) must be the
same.
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection
Preparation
1. Empty the condensation container a page 4 .
2. Select any programme using the programme selector.
3. Press the Start /Stop button a condensation is pumped into the container.
4. Wait 5 minutes and then empty the condensation container again.
5. Turn the programme selector to Off .
Transport
– Preparation of dryer a see Frost protection.
– Transport the dryer in a vertical upright position.
– Following transportation, leave the dryer to stand for two hours.
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
1.
Remove all accessories
from the drum.
The drum must be empty.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not install the dryer behind a door or sliding
door,
dryer door. This will prevent children from locking
themselves in and putting their lives in danger.
2.
Do not operate the dryer i
there is a danger of frost.
9
Only when the appliance is
switched off.
Care and cleaning
Heat ex
The heat exchanger of the dryer is cleaned automatically when drying is in progress, Cln
appears in the display panel. Do not pull the condensation container out during the cleaning
process.
Dryer housing, control panel, air intake
Wipe with a soft, damp cloth.
Do not use harsh cleaning agents or solvents.
Remove detergent and cleaning agent residue immediately.
Water may occasionally accumulate between the window and the seal. This does not impair
the functions of your dryer in any way.
Filter in the condensation tank
The filter is cleaned automatically when the condensation container is emptied.
However,
deposits/dirt from building up.
Cleaning is only required if the symbol ā flashes again in the display panel after the
condensation container has been emptied.
1. Pull out the condensation container.
2. Pull the filter out of its snap-in lock.
3. Clean the filter under running water or in the dishwasher.
4. Refit the filter.
5. Insert the condensation tank so that it locks into place.
Only operate the dryer with the filter inserted.
Moisture sensor
The
laundry is. After long periods of use, a fine layer of limescale can form on the moisture
sensors.
1. Open the door.
2. Clean the moisture sensors using a damp sponge with a rough surface.
Do not use steel wool or other abrasive materials.
1
Technical data
ʠ
Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable)
Weight approximately 53 kg
Max. capacity 7 kg
Condensation container 4.0 l
Connection voltage 220-240 V
Connected load max. 1000 W
Fuse protection 10 A
Ambient temperature 5 - 35°C
Product number
Production number
under the door
The rating plate can be found on the back of the dryer.
ʠ
Drum interior light (depending on model) (bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb a page 12 .
Consumption rates
Fabrics/programmes
Residual moisture in the fabrics
after spinning
Drying time**
Energy
consumption**
Cottons / Coloureds 7 kg
Cupboard Dry* 1400 rpm (50%) 133 min 1.60 kWh
1000 rpm (60%) 155 min 1.85 kWh
800 rpm (70%) 176 min 2.16 kWh
Iron Dry* 1400 rpm (50%) 96 min 1.10 kWh
1000 rpm (60%) 118 min 1.37 kWh
800 rpm (70%) 138 min 1.65 kWh
Synthetics 3.5 kg
Cupboard Dry* 800 rpm (40%) 54 min 0.57 kWh
600 rpm (50%) 68 min 0.72 kWh
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes Drying time Annual energy consumption
Cottons / Coloureds 7 kg / 3.5ü kg*
Cupboard Dry*** 124 min / per cycle 236ü kWh / per year
***
Optional accessories (from after-sales service using order number)
W
The
to must
WTZ 11300: with pull-out worktop.
Installation underneath the w
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
Platform
For easier loading and unloading. The basket contained in the drawer can be used
to carry the laundry.
WTZ
11310
WTZ
10290
WMZ
20500
1
Normal noises
During drying, the compressor and the pump generate some noise which is entirely normal.
The compressor in the dryer may
occasionally generate a droning noise.
The volume and pitch of this may vary
depending on the selected
programmes and the progress of the
drying.
The compressor in the dryer is ventilated
from time to time, which
sound.
The automatic cleaning process causes
a clicking noise.
The process of pumping the condensation
into the condensation container generates
pumping noises.
1
What to do if ...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried
local after-sales service can be found in the enclosed
after-sales service directory, or by
calling one of these numbers:
– GB
A call set-up fee of up to 6 pence may apply.)
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
When contacting
and production number (FD) (see the inside of the door).
Set the programme selector to Off and remove the appliance plug from the socket.
ʠ
The Start /Stop indicator
not light up.
Mains plug plugged in? Programme selected?
Check the socket fuse.
ʠ
The display panel light and
indicator lights (depending on
model) go out and the
Start/Stop indicator light flashes.
Energy-saving mode is activated a see the separate
Energy-saving mode instructions.
ʠ
The ā symbol and Start /Stop
indicator lamp flash.
Empty container for condensation a see page 4 .
Clean the condensation a Page 9 .
Each time the dryer is transported, you must wait two hours
before operating it.
ʠ
The 4 symbol and Start /Stop
indicator lamp flash.
Rinse the fluff filter under running water a Page 4.
ʠ
Dryer does not start. Start /Stop button selected? Door closed?
Programme set? Ambient temperature greater than 5 °C?
ʠ
Water is leaking out. Make sure the dryer is level.
ʠ
The door opens by itself. Push the door closed until you hear it click into place.
ʠ
Creasing. Laundry load exceeded?
Remove articles of clothing immediately after the end of the
programme, hang up and pull into shape.
Unsuitable programme selected a Page 7.
ʠ
Drying result is not satisfactory
(laundry feels too damp).
Warm laundry feels damper than it actually is.
The selected programme does not suit the load. Use another
drying programme or, in addition, select the time programme
a Page 7.
Use fine adjustment for the drying result a Page 1/2.
Fine layer of limescale on the humidity sensors
a Clean the humidity sensors a Page 9.
Programme termination, e.g. tank full, mains power supply
failure, door open or maximum drying time reached.
ʠ
Drying time too long. Rinse the fluff filters under running water a Page 4.
Insufficient supply of air a ensure that air can circulate.
Air inlet possibly blocked a Clear inlet a Page 8 .
Ambient temperature higher than 35 °C a ventilate the room.
ʠ
The
significantly.
Make sure the room is sufficiently ventilated.
ʠ
Cln appears in the display panel. Not an error! Automatic cleaning of the heat exchanger.
Do not empty the condensation container.
ʠ
Power cut. Remove the laundry from the dryer immediately and spread it
out. Heat may escape.
ʠ
The interior light is not working. Unplug
above the door (using a Torx 20 screwdriver) and replace the
bulb. Close the cover cap.
Never operate the dryer without a cover cap.
ʠ
Other intermittent noises and
vibrations.
Not an error!
Normal noises a Page 11 .
ʠ
Loud humming noise for several
seconds.
Has the condensation container been properly reinserted?
a Push the condensation tank all the way in.
Not an error! Normal noises a Page 11 .
1
Safety instructions
Emergency
– Pull the appliance
ONLY use the
dryer...
– in rooms inside the house.
– to dry fabrics.
The dryer must
NEVER...
– be used for purposes other than those described above.
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments.
Pay particular attention to cigarette lighters a Risk of explosion
– Do not lean or sit on the door a Risk of tipping.
Installation
– Secure loose cables a Tripping hazard.
– Do not operate the dryer where there is a risk of frost.
Mains
connection
– Connect the dryer according to specifications to an AC earthed socket,
otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
– Do not touch or hold the appliance plug with wet hands
a Risk of electric shock.
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead a Risk of electric shock.
Operation
– Only laundry must be loaded into the drum.
Before switching on the dryer - check the contents.
– Do
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.) a Fire/explosion hazard.
– Hazard caused by dust (e.g. coal dust, flour): do not use the dryer
a Risk of explosion!
– Do a elastic
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
– Switch off the dryer once the programme has ended.
– The
with fluff.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use a dryer with a faulty mains lead. To prevent risks, a faulty mains
lead must only be replaced by the after-sales service.
– Before changing
pulled the appliance plug from the socket a Risk of electric shock!
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Dryer: then
Dispose of the dryer at an approved public disposal facility.
– The
the Kyoto Protocol a dispose of in a proper manner. Capacity: 0.19 kg.
– Packaging: keep all packaging out of reach of babies and children.
a Danger of suffocation!
– All materials are environmentally safe and recyclable. Dispose of in an
environmentally-responsible manner.
Dryer
en Instruction manual
