7
ENERGY SAVING TIPS
To save energy, time and money, Bosch recommends
the following:
l Always spin dry the laundry in the washer at the
highest recommended speed for the fabric type.
The highest spin speed will result in a dryer load and
shorten the drying time and amount of energy
required to dry the load.
l Spin dry delicate washing before tumble drying.
l Load the dryer properly. Do not exceed the maximum
load (see CYCLE SELECTION CHART).
l Always clean the lint filter after each use of the dryer.
OPERATING TIPS
l Follow the fabric care labels on the clothing.
l Avoid very small loads. When only one or two items
need drying, add a few similar items to improve
drying efficiency.
l Do not mix heavyweight and lightweight clothing.
l Do not dry wool or fabrics with a wool content
l Do not dry fabrics that do not allow the free passage
of air (for example, GORETEX)
l Do not dry delicate fabrics such as, silk, synthetic net
curtains, etc.
BEFORE USING FOR THE FIRST TIME
Before beginning to use your dryer for the first
time:
1. Check to make sure that the voltage on
which the dryer is to operate is the same as
shown on the rating plate.
2. Wipe the interior of the drum with a damp cloth.
3. Thoroughly inspect the dryer for cosmetic damage.
GETTING STARTED
Below, in order to get started, you will find a summary of
how to operate the clothes dryer. Also, refer to the
CYCLE SELECTION CHART, Table 1.
l Turn On the Dryer
Press the ‘‘On/Off’’ button. The indicator light will
become illuminated and the indicator above the
‘Start’’ button will begin to flash.
l Check the Lint Filter
The lint filter, located in the door, should be cleaned
after or before each load.
l Load the Dryer
Load the items in the dryer.
l Add Fabric Softener Sheet
If a fabric softener sheet is to be added it should
be done after loading the dryer.
l Close the Dryer Door
l Select Cycle Desired
See CYCLE SELECTION CHART, Table 1, and
following section titled OPERATION for program
recommendations.
l Select Additional Functions (if desired)
See following section titled OPERATION.
l Press the ‘Start’’ Button
The ‘Start’’ indicator lamp will stop flashing and the
dryer will start. If one of the Auto-Cycles have been
selected the Duotronic system will monitor the
moisture level and display the progress of the drying
in the ‘‘Moisture Level Indicator Lights.’’ If a timed
cycle has been selected the minutes remaining will
be displayed in the ‘‘Cycle Countdown Display.’’
The cycle will continue to the end, when the ‘‘End’’
indictor lamp will become illuminated. And, if the
‘‘End of Cycle Signal’’ has been selected a signal will
sound. – See following section OPERATION on how
to set or turn of the ‘‘End of Cycle’’ signal.
l Depress the ‘‘Door’’ Button
The door will open.
l Remove the Laundry from the Dryer
l Clean the Lint Filter
l Turn Off the Dryer
Depress the ‘‘On/Off’’ button.
