746799
46
Zoom out
Zoom in
Previous page
1/56
Next page
en Faults and what to do about them
46
Information on the display panel
Faults and what to do about them
Fault code
‹˜“¯ The door is not properly closed. Close the door.
“‚ The water control system has been activated. Disconnect the appliance from the
mains, turn off the tap and advise the after-sales service.
Ҡ Water is not entering the appliance. See the fault Water is not flowing in
“‡ ˜—¯˜ The water is not Drained. See the fault Water is not Drained
—Ÿ –©‘š Not a fault! The unbalanced load detection system has detected an unbalanced
load caused by laundry items. The fluff removal cycle cannot start. Remove the
laundry.
•‚ “Ÿš
–‹ “Ÿš
Maximum or minimum drying load not taken into account. HI/End or LO/End
flash alternately in the display. See information for the Drying result not satisfac-
tory fault..
Other fault codes are only for use by the after-sales service. Make a note of the fault code to inform the
after sales service.
Fault Possible cause Remedial Action
Programme does not
start
The Start/Pause I button has not
been pressed.
Press the Start/Pause I button.
A delayed start time has been selected.. Washer dryer starts on completion
ofthe delay period. Change the “finished
in time” if necessary.
Power cut.The delayed start time that
was selected has been cleared.
Reselect the delayed start time or start-
the programme immediately. Press the
Start/Pause I button.
The door is not properly closed. Close the door.
Plug not inserted properly into socket. Insert plug correctly
The maximum spin
speed cannot be set.
The maximum spin speed depends on
the programme selected.
Change programme as required.
The water is not
Drained.
Drain hose is twisted.. Fit the Drain hose correctly.
Detergent pump is blocked. Clean the Drain pump .
Detergent residues in
the detergent drawer.
Damp or lumpy detergent. Clean and dry the detergent drawer .
Use the measuring aid for liquid deter-
gent.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WKD28352GB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WKD28352GB in the language / languages: English as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info