41
Display panel/indi-
cator lights do not
function while the
appliance is running.
–Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service. ~ Page 42
The programme
takes longer than
usual.
– Not a fault – unbalanced load detection system adjusts imbal-
ance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
Detergent residue
on the washing.
– Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select Rinse/Freshen up or brush the laundry after washing.
In the pause status
Start/Pause
A
flashes very quickly
and a signal sounds.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select Start/Pause
A to continue the programme.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service. ~ Page 42
Faults Cause/Remedy
