600706
24
Zoom out
Zoom in
Previous page
1/32
Next page
en Faults and what to do about them.
24
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not
satisfactory.
Laundry is wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Anti-crease (depending on the model) selected?
Is the selected speed too low?
The spin cycle runs
several times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The program is taking
longer than usual.
Not a fault – the unbalanced load detection system is adjusting an imbalance
by repeatedly distributing the laundry.
Not a fault – the foam detection is system active – a rinse cycle has been
switched on.
The length of the program
changes during the wash
cycle.
Not a fault – the program sequence is optimised for the specific washing
process. This may change the length of the program shown in the display panel.
Residual water in the care-
product compartment i.
Not a fault – the effect of the care product is not affected.
Clean the insert if necessary.
Odours in the washing
machine.
Depending on the model, run the Û Drum Clean 90 °C or i Cottons 90 °C
program without laundry.
Add washing powder or a detergent containing bleach.
Note: To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents designed for wool or
delicates.
The Åsymbol lights up
in the display panel. Foam
may also be leaking from
the detergent drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into com-
partment II (not suitable for outdoor clothing, sportswear or items stuffed with
down).
Use less detergent in the next wash cycle.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
Is the appliance aligned? Align the appliance ~ Page 30
Are the appliance's feet fixed? Secure the appliance's feet ~ Page 30
Have the transport braces been removed?
Remove the transport braces
~ Page 27
The display panel/indica-
tor lights do not work while
the appliance is running.
Has there been a power failure?
Have the fuses blown? Reset/replace the fuses.
If the fault occurs repeatedly, call customer services.
There is detergent residue
on the laundry.
Some phosphate-free detergents contain water-insoluble residue.
Select ' Rinse/Freshen up//Rinse or brush the laundry after washing.
The è symbol lights up in
the display in pause mode.
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary.
Press the A button to continue the program.
In the pause mode, the è
symbol in the display is off.
The door is unlocked. It is possible to add laundry.
If you cannot rectify a fault yourself (after switching the machine off and on again) or a repair is required:
Switch off the appliance and pull out the mains plug.
Turn off the tap and call customer services.
Faults Cause/Remedy
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WAP28480 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WAP28480 in the language / languages: English as an attachment in your email.

The manual is 4,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch WAP28480

Bosch WAP28480 User Manual - German - 32 pages

Bosch WAP28480 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info