600706
23
Zoom out
Zoom in
Previous page
1/32
Next page
Faults and what to do about them. en
23
Information on the display panel
Faults and what to do about them.
Display Cause/Remedy
è Flashes fast + signal: The door was opened and the water level is too high.
Close the door, continue the programme with A button or select 0 Spin/Drain
[ programme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
r Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean the
water inlet filter.
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required ~ separate installation and cleaning
instruction for water filter.
Water hose kinked or blocked?
Lights up (low water pressure): For information only. This will not affect the pro-
gramme progress. The programme duration is extended.
E:18 Drain pump blocked; clean the drain pump. Clean the drainage hose on the siphon.
E:32 Alternating display with End when programme is finished: unbalance problem, spin-
ning phase is aborted.
Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.
Faults Cause/Remedy
Water is leaking from the
machine.
Attach the drain hose correctly or replace it.
Tighten the screw connection of the drain hose.
The machine is not filling
with water.
Detergent is not being
dispensed.
Have you pressed the A button?
Is the tap turned on?
Could the filter be clogged? Clean the filter ~ Page 22
Note: If an additional water filter has been installed (depending on the
model), check for contaminants and clean if required ~ separate installa-
tion and cleaning instruction for water filter.
Is the supply hose kinked or trapped?
The door cannot be
opened.
The safety function is activated. Stop the program?
Is “- - - -” selected (Rinse Stop = no final spin)?
Can the door only be opened by the emergency release?
The program will not start. Have you pressed the A or ñ Ready in//Finished in button?
Is the door closed?
Is the E childproof lock activated? Deactivate.
The drum briefly jerks or
judders after the program
has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash program starts.
The water is not draining. Is “- - - -” selected (Rinse Stop = no final spin)?
Clean the drain pump ~ Page 20
Clean the drain pipe and/or the drain hose.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WAP28480 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WAP28480 in the language / languages: English as an attachment in your email.

The manual is 4,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch WAP28480

Bosch WAP28480 User Manual - German - 32 pages

Bosch WAP28480 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info