550928
25
Zoom out
Zoom in
Previous page
1/36
Next page
Faults and what to do about them. en
25
Water not visible in the
drum.
Not a fault – water below the visible area.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the spin
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
Reduced Ironing selected?
Selected speed too low?
Spin cycle started and
stopped several times.
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
The programme duration
is longer than usual.
Not a fault – the unbalanced-load detection system is adjusting the imbal-
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system active – adds an additional rinse
cycle.
The programme duration
changes during the wash
cycle.
Not a fault – the programme sequence is optimised for the particular washing
process. This may lead to changes in the programme duration in the display
panel.
Residual water in the
compartment for care
products.
Not a fault – the effect of the care product is not affected.
Clean the insert if necessary ~ Page 21
Odours in the washing
machine.
Run Cottons 90 °C programme without washing.
Use standard detergent.
The N symbol flashes in
the display panel. Foam
may escape from the
detergent drawer.
Too much detergent used?
Mix one tablespoon of fabric softener with 1/2 litre water and pour into com-
partment II (not for outdoor fabrics or those made with down).
Reduce the detergent dosage for the next wash cycle.
Intense noise, vibrations
and "wandering" during
spinning.
Are the appliance feet fixed? Secure the appliance feet. ~ Page 33
Transport locks removed? Remove the transport locks. ~ Page 30
Noises during spin and
drain cycles.
Clean the detergent solution pump ~ Page 21
Display panel/indicator
lamps do not function dur-
ing operation.
Power cut?
Circuit breakers tripped? Switch the circuit breakers back on or replace
them.
If the fault occurs repeatedly, call the after-sales service.
Detergent residues on the
laundry.
Occasionally, phosphate-free detergents contain water-insoluble residues.
Select Rinse/Spin or brush the laundry after washing.
NO appears on the dis-
play in reload mode.
Water level too high. Not possible to add laundry. Close the washing
machine door immediately, if necessary.
Select Start/Reload to continue the programme.
Faults Cause/remedial action
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WAE28369 - Classixx 7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WAE28369 - Classixx 7 in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info