Overview of programmes a refer to the table of consumption values on page 8 and notes on page 6.
Programmes°Cmax.
Type of laundry
Additional functions; information
Cottons20, 30, 40, 60, 90 °C6 kg
Hard-wearing fabrics, heat-resistant fabrics made of cot-
ton or linen
Rinse Plus, Express Wash
Easy-Care30, 40 °C
3 kg
Easy-care fabrics made of cotton, linen, synthetic fibres or
blended fabrics
Rinse Plus, Express Wash
Mixed Load30 °CFabrics made of cotton or easy-care fabrics
Rinse Plus, Express Wash;
different types of laundry can be washed together
Delicates30 °C
2 kg
For delicate, washable fabrics, e.g. made of silk, satin,
synthetic fibres or blended fabrics (e.g. curtains)
Rinse Plus, Express Wash;
No spin between rinse cycles
:÷/ Wool30 °C
Handä or machine-washable fabrics made of wool or con-
taining wool
Particularly gentle wash programme to prevent shrink-
age of laundry. Longer programme breaks (fabrics rest
in the detergent solution)
Additional
programmes
Rinse, Spin, Drain
Programmes without prewash - add detergent to compartment II, programmes with prewash - distribute the detergent between compartments Iand II (model-dependent).
9403 / 9000978497
*978497*
WAE24063GB ...
Robert Bosch Hausgeräte GmbH
Carl-Wery-Str. 34
81739 München / Deutschland
8
Safety instructions
–Read the instruction manual and installation instructions and all other information enclosed
with the washing machine and act accordingly.
–Retain the documents for subsequent use.
Risk of electric shock–Never pull the cable to disconnect the mains plug.
–Never insert/disconnect the mains plug with damp hands.
Danger to lifeFor worn-out appliances:
–Disconnect the mains plug.
–Sever the mains cable and discard along with the plug.
–Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and risking their lives.
Danger of suffocation–Keep packaging, film and packaging parts out of the reach of
children.
Risk of poisoning–Keep detergents and care products out of the reach of children.
Risk of explosion–Items of laundry pretreated with cleaning agents containing
solvents, e.g. stain remover/cleaning solvent may cause an
explosion after being loaded into the washing machine.
Rinse items of laundry thoroughly by hand beforehand.
Risk of injury–The washing machine door can become very hot.
–Be careful when draining hot detergent solution.
–Do not climb onto the washing machine.
–Do not lean on the open washing machine door.
–Do not reach into the drum if it is still rotating.
–Be careful when opening the detergent drawer while the machine
is in operation.
Consumption valuesdepending on model
ProgrammeLoadElectricity**Water**
Programme
duration**
Cottons 20 °C6 kg0,33 kWh62 l1 B h
Cottons 40 °C6 kg0,78 kWh62 l2 h
Cottons 60 °C6 kg1,22 kWh62 l2 @ h
Cottons 90 °C6 kg1,94 kWh65 l2 @ h
Easy-Care 40 °C3 kg0,61 kWh52 l1 B h
Mixed Load 30 °C3 kg0,27 kWh60 l1 h
Delicates 30 °C
2 kg0,29 kWh51 lB h
:/ Wool 30 °C
2 kg0,17 kWh33 l1 h
ProgrammeLoad
Annual energy
consumption
Annual water
consumption
Cottons / ~*6 kg 152 kWh10120 l
*Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water
(15 ºC).
**The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient
temperature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected
additional functions.
9
Care
Before washing for the first time
Do not load any laundry into the machine. Turn on the tap.
Add the following to compartment II:
–approx. 1 litre water
–detergent (dosage according to the manufacturer's instructions for light soiling and the
appropriate degree of water hardness)
Set the programme selector to Cottons 60 °C and select Start.At the end of the programme,
turn the programme selector to Off.
Machine housing, control panel
–Wipe with a soft, damp cloth.
–Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
–Remove detergent and cleaning agent residue immediately.
–Do not clean with a jet of water.
Cleaning thedetergent drawer and housing...
... if it contains detergent or fabric softener residues.
1.Pull the drawer out, press down the insert and fully remove the drawer
from the housing.
2.To remove the insert: press the insert upwards from below with your
finger.
3.Clean the detergent dispenser tray and insert with water and a brush and
dry it. Also remove any detergent or fabric softener residues in the
housing.
4.Attach the insert and engage (connect the cylinder to the guide pin).
5.Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can
evaporate.
Washing drum and rubber seal
Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so
that the drum can dry out. Rust stains - use chlorine-free cleaning agent, not steel wool.
DescalingEnsure there is no laundry in the machine
Descale the appliance according to the descaler manufacturer's instructions. This should not
be necessary if the correct dosage of detergent is used.
Information to indicator lights
Indicator lights for status displays and/or buttons flash:
Indicator lights
Rinse and
Wash flash
Close the washing machine door properly; laundry may be caught.
Indicator lights
Spin and
Wash flash
Open the tap completely, supply hose kinked or trapped;
Clean the filter apage 10, Water pressure too low.
Indicator lights
Spin and
Rinse flash
Detergent solution pump blocked; Clean the detergent solution pump
apage 10.
Drainage hose/waste pipe blocked; Clean the drainage hose at the
siphon apage 10.
Indicator light
Rinse flashes
Motor fault. Call the after-sales service.
All indicator lights flashTurn off the tap and call the after-sales service.
–Risk of electric shock.Disconnect the mains plug.
–Risk of explosion.No solvents.
10
Maintenance
Detergent solution pump
Turn the programme selector to Off and disconnect the mains plug.
1.Open and remove the service flap.
2.For models with a drainage hose: Remove the drainage hose from the retainer and pull it
from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
2*For models without a drainage hose:Carefully unscrew the pump cover until the
detergent solution begins to flow out. When the service flap is half full, close the pump cover
and empty the service flap. Repeat the above steps until all the detergent solution has
completely drained out.
3.Carefully unscrew the pump cover (residual water).
4.Clean the interior, pump cover thread and pump housing (the impeller in the detergent
solution pump must rotate).
5.Replace the pump cover and screw it tightly in place.
6.Place the service flap back on and close.
To prevent unused detergent from flowing straight into the drain during the next wash: pour 1 litre of water into
compartment II and start the Drain programme.
Drainage hose at the siphon
Turn the programme selector to Off and disconnect the mains plug.
1.Loosen the hose clamp, carefully remove the drainage hose (residual water).
2.Clean the drainage hose and siphon connecting piece.
3.Reattach the drainage hose and secure the connection with the hose clamp.
Filter in the water supply
Reduce the water pressure in the supply hose:
1.Turn off the tap.
2.Select any programme (except for Spin / Drain).
3.SelectStart. Let the programme run for approximately 40 seconds.
4.Turn the programme selector to Off. Disconnect the mains plug.
Clean the filter:
1.Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and Aqua-Secure models:
Remove the hose on the rear of the appliance.
Remove the filter with pliers and clean.
2.Connect the hose and check for leaks.
–Risk of scalding.
Allow the detergent solution to cool down.
–Turn off the tap.
11
What to do if ...
ʑ
Water is leaking out.–Attach/replace the drainage hose correctly.
–Tighten the screw connection of the supply hose.
ʑ
No water supply.
Detergent not dispensed.
–Start not selected?
–Tap not turned on?
–Filter blocked? Clean the filter a page 10.
–Supply hose kinked or trapped?
ʑ
Washing machine door
cannot be opened.
–Safety function active. Wait approx. 2 minutes.
ʑ
Programme does not
start.
–Start selected?
–Washing machine door closed?
ʑ
Detergent solution is not
drained.
–Clean the detergent solution pump a page 10.
–Clean the waste pipe and/or drainage hose.
ʑ
Water not visible in the
drum.
–Not a fault - water below the visible area.
ʑ
Unsatisfactory spin
result.
Laundry wet/too damp.
–Not a fault - the unbalanced-load detection system has cancelled
the spin cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the
drum.
ʑ
Spin cycle performed
several times.
–Not a fault - unbalanced load detection system adjusts the
imbalance.
ʑ
Residual water in the
compartment for care
products.
–Not a fault - the action of the care product is not affected.
–Clean the insert if necessary a page 9.
ʑ
Odour formation in the
washing machine.
–Run programme Cottons 90 °C without laundry. Use standard
detergent.
ʑ
Foam escaping from the
detergent drawer.
–Too much detergent used?
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II(not with outdoor or down fabrics).
–Reduce the detergent dosage for the next wash cycle.
ʑ
Intense noise formation,
vibrations and “walking”
during the spin cycle.
–Are the appliance feet fixed?
Secure the appliance feet a Installation instructions.
–Transportation safety devices removed?
Remove the transportation safety devices a Installation
instructions.
ʑ
Noises during spin and
drain cycles.
–Clean detergent-solution pump apage 10.
ʑ
The indicator lights do
not function during
operation.
–Power cut?
–Fuses tripped? Reset/change the fuse.
–If the fault occurs repeatedly, call the after-sales service.
ʑ
Programme sequence
longer than usual.
–Not a fault - unbalanced load detection system adjusts
imbalance by repeatedly distributing the laundry.
–Not a fault - foam detection system active - adds an additional
After cycle completed the start and wash indicators flash and will not allow the door to release , this is after the load has been removed
Submitted on 28-5-2024 at 15:55
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Bosch WAE24063 - Maxx 6 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Bosch WAE24063 - Maxx 6 in the language / languages: English as an attachment in your email.
The manual is 3,45 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
